In this paper, a low-power and small-area Single Edge Nibble Transmission (SENT) transmitter design is proposed for automotive pressure and temperature complex sensor applications. To reduce the cost and size of the hardware, the pressure and temperature information is processed with a single integrated circuit (IC) and transmitted at the same time to the electronic control unit (ECU) through SENT. Due to its digital nature, it is immune to noise, has reduced sensitivity to electromagnetic interference (EMI), and generates low EMI. It requires only one PAD for its connectivity with ECU, and thus reduces the pin requirements, simplifies the connectivity, and minimizes the printed circuit board (PCB) complexity. The design is fully synthesizable, and independent of technology. The finite state machine-based approach is employed for area efficient implementation, and to translate the proposed architecture into hardware. The IC is fabricated in 1P6M 180 nm CMOS process with an area of (116 μm × 116 μm) and 4.314 K gates. The current consumption is 50 μA from a 1.8 V supply with a total 90 μW power. For compliance with AEC-Q100 for automotive reliability, a reverse and over voltage protection circuit is also implemented with human body model (HBM) electro-static discharge (ESD) of +6 kV, reverse voltage of −16 V to 0 V, over voltage of 8.2 V to 16 V, and fabricated area of 330 μm × 680 μm. The extensive testing, measurement, and simulation results prove that the design is fully compliant with SAE J2716 standard.
In this article, a highly reliable radio frequency (RF) wake-up receiver (WuRx) is presented for electronic toll collection (ETC) applications. An intelligent digital controller (IDC) is proposed as the final stage for improving WuRx reliability and replacing complex analog blocks. With IDC, high reliability and accuracy are achieved by sensing and ensuring the successive, configurable number of wake-up signal cycles before enabling power-hungry RF transceiver. The IDC and range communication (RC) oscillator current consumption is reduced by a presented self-hibernation technique during the non-wake-up period. For accommodating wake-up signal frequency variation and enhancing WuRx accuracy, a digital hysteresis is incorporated. To avoid uncertain conditions during poor and false wake-up, a watch-dog timer for IDC self-recovery is integrated. During wake-up, the digital controller consumes 34.62 nW power and draws 38.47 nA current from a 0.9 V supply. In self-hibernation mode, its current reduces to 9.7 nA. It is fully synthesizable and needs 809 gates for its implementation in a 130 nm CMOS process with a 94 × 82 µm2 area. The WuRx measured power consumption is 2.48 µW, has −46 dBm sensitivity, and a 0.484 mm² chip area.
In this paper, an ultra-low power, adaptive all-digital integer frequency-locked loop (FLL) with gain estimation and constant current digitally controlled oscillator (DCO) for Bluetooth low energy (BLE) transceiver in Internet-of-Things (IoT) is presented. For locking DCO frequency closest to the target channel, it adaptively controls capacitor banks with binary algorithm. With decrease in frequency resolution, DCO clock counts for each capacitor bank bit evaluation dynamically increases with the proposed technique for accurate frequency tracking. For compensating PVT variations and finding the BLE frequency deviation, the configurable digital DCO gain estimation is incorporated. The low power and constant current DCO operates in sub-threshold region and its power consumption is minimized by g m /I D methodology optimization, constant current source for limiting current in DCO core through adaptive low-dropout regulator (LDO) and lowering the supply voltage. The proposed design is integrated in an ADPLL for BLE transceiver and it is fabricated with 1P6M TSMC 55 nm CMOS technology. The all-digital adaptive FLL is fully synthesizable and its area is 1800 µm 2 with 1.233 K gate count. The RMS current consumption is 103.32 µA from 1 V voltage supply with 103.32 µW power requirement. The experimental results reveal, DCO draws 480 µA current from 0.55 V supply voltage at center frequency. It has frequency resolution of 4.8 kHz. The oscillator PN, FOM and FOM T at 1-MHz offset frequency from 2.44 GHz carrier frequency are −122.85 dBc/Hz, 196.38 dBc/Hz and 208.19 dBc/Hz, respectively. INDEX TERMS Adaptive controller, all-digital frequency locked loop, digitally controlled oscillator, gain estimation, constant current, LDO, ultra-low power, synthesizable.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.