In this paper, a low-power and small-area Single Edge Nibble Transmission (SENT) transmitter design is proposed for automotive pressure and temperature complex sensor applications. To reduce the cost and size of the hardware, the pressure and temperature information is processed with a single integrated circuit (IC) and transmitted at the same time to the electronic control unit (ECU) through SENT. Due to its digital nature, it is immune to noise, has reduced sensitivity to electromagnetic interference (EMI), and generates low EMI. It requires only one PAD for its connectivity with ECU, and thus reduces the pin requirements, simplifies the connectivity, and minimizes the printed circuit board (PCB) complexity. The design is fully synthesizable, and independent of technology. The finite state machine-based approach is employed for area efficient implementation, and to translate the proposed architecture into hardware. The IC is fabricated in 1P6M 180 nm CMOS process with an area of (116 μm × 116 μm) and 4.314 K gates. The current consumption is 50 μA from a 1.8 V supply with a total 90 μW power. For compliance with AEC-Q100 for automotive reliability, a reverse and over voltage protection circuit is also implemented with human body model (HBM) electro-static discharge (ESD) of +6 kV, reverse voltage of −16 V to 0 V, over voltage of 8.2 V to 16 V, and fabricated area of 330 μm × 680 μm. The extensive testing, measurement, and simulation results prove that the design is fully compliant with SAE J2716 standard.
Summary
This paper presents a 6‐bit 4 MS/s segmented successive approximation register analog‐to‐digital converter for Bluetooth low energy transceiver applications. To improve the linearity and reduce the switching power consumption, a segmented structure with new switching scheme is adopted in the capacitive digital‐to‐analog converter. The proposed switching sequence determines the MSBs according to the thermometer codes and skips some of the unnecessary steps while avoiding bubble errors. To ensure the common mode voltage remains comparatively steady, and to avoid employing power‐hungry common mode reference voltage circuits, each capacitor is divided into 2 identical small capacitors, connecting one of them to “high” and the other one to “low”. The switching sequence is straightforward, and a split capacitor with an integer value is applied, which almost halves the total number of capacitors while retaining the unit capacitor value intact. The prototype analog‐to‐digital converter is fabricated and measured in a 55‐nm (shrinked 65 nm) complementary metal‐oxide semiconductor process and achieves 5.48 to 5.92 Effective Number of Bits (ENOB) at a sampling frequency of 4 MS/s. The Signal to Noise and Distortion Ratio (SNDR) and Spurious Free Dynamic Range (SFDR) for Nyquist input frequency are 34.79 and 40.03 dB, respectively. The current consumption is 4.8 μA from a 1.0‐V supply, which corresponds to the figure of merit of 26 fJ/conversion‐step. The total active area of the analog‐to‐digital converters for the I and Q paths of the receiver is 105 μm × 140 μm.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.