No abstract

No abstract

No abstract

More and more lighting applications require the design of dedicated optics to achieve a given radiant intensity or irradiance distribution. Freeform optics has the advantage of providing such a functionality with a compact design. It was previously demonstrated in [Bäuerle et al., Opt. Exp. 20, 14477-14485 (2012)] that the up-front computation of the light path through the optical system (ray mapping) provides a satisfactory approximation to the problem, and allows the design of multiple freeform surfaces in transmission or in reflection. This article presents one natural extension of this work by introducing an efficient optimization procedure based on the physics of the system. The procedure allows the design of multiple freeform surfaces and can render high resolution irradiance patterns, as demonstrated by several examples, in particular by a lens made of two freeform surfaces projecting a high resolution logo (530 × 160 pixels).

The design of freeform lenses and reflectors allows to achieve non-radially symmetric irradiance distributions whilst keeping the optical system compact. In the case of a point-like source, such as an LED, it is often desired to capture a wide angle of source light in order to increase optical efficiency. This generally results in strongly curved optics, requiring both lens surfaces to contribute to the total ray refraction, and thereby minimising Fresnel losses. In this article, we report on a new design algorithm for multiple freeform optical surfaces based on the theory of optimal mass transport that adresses these requirements and give an example of its application to a problem in general lighting.

Here we present a novel laser process to generate carbon nanofiber nonwovens from polyacrylonitrile. We produce carbon nanofabrics via electrospinning followed by infrared laser-induced carbonization, facilitating high surface area and well-controlled hierarchical porosity. The process allows precise control of the carbonization conditions and provides high nanoscale porosity. In comparison with classical thermal carbonization, the laser process produces much higher surface areas and smaller pores. Furthermore, we investigate the carbonization performance and the morphology of polyacrylonitrile nanofibers compounded with graphene nanoplatelet fillers.

Aeronautical applications often require small batches of large-scale sheet metal parts made from titanium and its alloys. Due to the low formability of titanium at room temperature, warm forming processes are necessary. Incremental sheet metal forming (ISF) is suitable for production of prototypes and small batches as well as large-scale parts. A short review of the experimental work done by international scientists in the field of warm ISF including stationary and moved temperature sensors will be presented mostly applied from the backside of the sheet metal. The present paper shows a new approach for a tool setup including a thermocouple inside of the tool. Hence, the sensor for temperature measurement was moved with the forming zone. Furthermore, a suitable closed loop control including a PID controller will be presented. The characteristics of the controller will be discussed. By means of two different warm ISF processes (ISF with resistance heating and laser-assist ed ISF), the applicability of the developed setup will be analysed and evaluated. It will be shown that the experimental setup is capable to ensure minimal temperatures needed to ensure adequate formability of Ti grade 5

No abstract