No abstract

No abstract

No abstract

Triclosan has been formulated into a dentifrice at a 0.3% level to enhance the antibacterial function of the dentifrice, to improve oral health and to decrease the daily malodor inside the mouth cavity. The hypothesis that chloroform may be generated from triclosan when contacted with chlorinated drinking water has challenged our guarantee of safe use of triclosan in oral care products, especially in Colgate Total toothpaste. Currently, there was no available analytical method to detect chloroform levels under the use conditions expected during daily tooth brushing. To fill this gap and to continue guaranteeing that our customers can safely use Colgate Total toothpaste products, a gas chromatography-single ion monitoring-mass spectrometry method for detecting chloroform in artificial saliva media has been developed. The limit of detection (LOD) and limit of quantitation are about 41 and 130 ppb, respectively. This LOD level is lower than the current Environmental Protection Agency trihalomethanes contamination limit, which is required for our daily drink water. Our in vitro study indicated that Colgate Total does not form detectable chloroform levels (41 ppb) over the range of expected consumer-brushing times while using normal chlorinated drinking water.

Different hydrophilic interaction chromatography (HILIC) columns were screened for lactic acid separation in hand dishwashing liquid products and the influence of mobile phase strength, buffer concentration and column temperature on the retention of lactic acid on a Zorbax NH(2) column was investigated. An isocratic HILIC method for the quantitation of lactic acid in hand dishwashing liquid products was developed. The mobile phase consists of 70% methanol and 30% 20 mM sodium phosphate buffer (v/v) at pH 2.5. The HILIC stationary phase is Zorbax NH(2), 250x4.6 with a 5 microm particle size. Detection was carried out using a variable wavelength UV-VIS detector at 226 nm. The linear range and percent recovery for lactic acid in the products were 44.68-1206.39 microg/mL and 100.3%, respectively. This paper provides an optimized HILIC methodology for the analysis of an acidic polar analyte (lactic acid) on a basic stationary phase. The proposed method can be used for the routine analysis of lactic acid.