One of the most common methods of carbon nanotubes (CNTs) synthesis is application of an electric-arc plasma. However, the final product in the form of cathode deposit is composed of carbon nanotubes and a variety of carbon impurities. An assay of carbon nanotubes produced in arc discharge systems available on the market shows that commercial cathode deposits contain about 10% CNTs. Given that the quality of the final product depends on carbon–plasma jet parameters, it is possible to increase the yield of the synthesis by plasma jet control. Most of the carbon nanotubes are multiwall carbon nanotubes (MWCNTs). It was observed that the addition of catalysts significantly changes the plasma composition, effective ionization potential, the arc channel conductance, and in effect temperature of the arc and carbon elements flux. This paper focuses on the influence of metal components on plasma-jet forming containing carbon nanotubes cathode deposit. The plasma jet temperature control system is presented.

In this paper, a novel approach to the synthesis of the carbon nanotubes (CNTs) in reactors operating at atmospheric pressure is presented. Based on the literature and our own research results, the most effective methods of CNT synthesis are investigated. Then, careful selection of reagents for the synthesis process is shown. Thanks to the performed calculations, an optimum composition of gases and the temperature for successful CNT synthesis in the CVD (chemical vapor deposition) process can be chosen. The results, having practical significance, may lead to an improvement of nanomaterials synthesis technology. The study can be used to produce CNTs for electrical and electronic equipment (i.e., supercapacitors or cooling radiators). There is also a possibility of using them in medicine for cancer diagnostics and therapy.

Conjugates of FA attached to MWNTs via peptide linkers prepared from β-alanine residues are resistant to proteolytic degradation. Viability in colon cancer cells and normal colonocytes confirmed their lack of cytotoxicity.

A 48-year-old man drank 150 mL of an aqueous solution containing potassium dichromate 22.5 g in a suicidal attempt and was admitted 7 hours after the ingestion. Hemodialysis was promptly undertaken and chromium concentrations in serum, erythrocytes, and dialysate were determined during the treatment. Chromium elimination in urine was monitored during hemodialysis and the subsequent 400 hours. The total chromium eliminated via hemodialysis and urine was calculated as 36.7 mg or 0.16% of the ingested dose. Spontaneous urinary elimination proceeded according to an open one-compartment model. The elimination half-life was 71.37 hours +/- 17.13 hours (95% CI). Chromium elimination from serum followed an open two-compartment model, with the half-lives of 3.16 hours +/- 2.63 hours for phase 1 and 50 hours +/- 27 hours (95% CI) for phase 2. Calcium-EDTA therapy had no influence on erythrocyte, serum, or urine chromium level. It contributed, however, to a significant increase in chromium elimination rate in the dialysate. Serum zinc was very low at admission and serum zinc, copper, and magnesium were controlled during the initial 30 hours.

No abstract

No abstract

No abstract

One of the most effective ways of synthesizing carbon nanotubes is the arc discharge method. This paper describes a system supported by a magnetic field which can be generated by an external coil. An electric arc between two electrodes is stabilized by the magnetic field following mass flux stabilization from the anode to the cathode. In this work four constructions are compared. Different configurations of cathode and coils are calculated and presented. Exemplary results are discussed. The paper describes attempts of magnetic field optimization for different configurations of electrodes.