The microstructures of the activated carbon black microparticles (ACBMPs) generated through both treatments of 20 min ultrasonic and 400 C thermal energy equivalent have been analyzed properly using scanning electron microscope (SEM), X-ray diffraction (XRD) and Fourier-transformed infrared (FTIR) spectroscopy methods. The research was aiming to generate binding or active sites points on the outer surface of the ACBMPs body of which commonly plays an important role in both adsorption and catalytic processes. It was observed that around 150 nm up to 400 nm in average diameter super macro voids with many various turns of nano-scale wells, and around 1.84 angstrom (Å) up to 15.98 Å intraparticle pores were generated. In addition, the parallel planes spacing of the carbonaceous framework sheets, namely d hkl in Miller indexes terminology, of about 4.44 Å up to 2.98 Å constructed the inner particles of the ACBMPs body. A new nomenclature method for the binding or active site shapes identification and classifying them into four categories based on the quadrants terminology, i.e. quadrant one (Q1), two (Q2), three (Q3) and four (Q4) is proposed. Each the quadrants contains four categories of turns types, i.e. sharp, semi sharp, obtuse and non-significant turns depending on the angle of the associated turn in radian angle, θ. Finally, it can be concluded that the combination of ultrasonic and thermal energy treatments in fabricating ACBMPs could generate binding or active site points with unique shapes as a transit terminal for any guest molecules, in this context is methyl red (MR) molecules to enter into the suitable intra-particles pores of the ACBMPs body.

No abstract

<p>This paper presents a characterization of an integrated ozone generator constructed by seven of reactors of Dielectric Barrier Discharge Plasma (DBDP). DBDP a has spiral-cylindrical configuration. Silence plasma produced ozone inside the DBDP reactor was generated by AC-HV with voltage up to 25 kV and maximum frequency of 23 kHz. As a source of ozone, dry air was pumped into the generator and controlled by valves system and a flowmeter. We found ozone concentration increased with the applied voltage, but in contrary, the concentration decreased with the flow rate of dry air. It was also found that a maximum concentration was 20 mg/L and ozone capacity of 48 g/h with an input power of 1.4 kW. Moreover, in this generator, IP efficiency of 8.13 g/kWh was obtained at input power 0.45 kW and air flow rate of 9 L/min. Therefore, be the higher ozone capacity can be produced with higher input power; however, it provided lower IP efficiency. The effect of dry air flow rate and applied voltage on ozone concentrations have been studied. At last, spiral wire copper was very corrosive done to the interaction with ozone, and it is necessary to do a research for finding the best metals as an active electrode inside of the quartz dielectric. Copyright © 2017 BCREC GROUP. All rights reserved</p><p><em>Received: 18^th July 2016; Revised: 25^th September 2016; Accepted: 5^th October 2016</em></p><p><strong>How to Cite:</strong> Nur, M., Susan, A.I., Muhlisin, Z., Arianto, F., Kinandana, A.W., Nurhasanah, I., Sumariyah, S., Wibawa, P.J., Gunawan, G., Usman, A. (2017). Evaluation of Novel Integrated Dielectric Barrier Discharge Plasma as Ozone Generator. <em>Bulletin of Chemical Reaction Engineering &amp; Catalysis</em>, 12 (1): 24-31 (doi:10.9767/bcrec.12.1.605.24-31)</p><p><strong>Permalink/DOI</strong>: http://dx.doi.org/10.9767/bcrec.12.1.605.24-31</p><p> </p>

Background: Diabetes is a disease that affects people worldwide, including in Indonesia. The prevalence of diabetes in Indonesia is increasing from year to year. One of the most devastating complications of diabetes mellitus is diabetic ulcers, which is a limb-threatening complication. Over the past few decades, ozone generated using plasma medical technology has been investigated as an agent that helps wound healing. This study aims to evaluate the effects of topical ozonated virgin coconut oil (VCO) in a diabetic wound mouse model. Methods: This study was an experimental study with a post-test control design. An ulcer wound model was made in 50 diabetic male Wistar mice, divided into five groups, and a control group of 10 non-diabetic mice. The control groups were given conventional therapy only and the treatment groups were also given topical ozonated VCO with different flow durations (0 min, 90 min, 7 h, 14 h). Macroscopic appearance and wound contraction were observed. HSP90β, VEGF-A, EGF, bFGF and CD34 levels were measured from the immunostained slices of wound margins. Results: The reduction of wound length was proportionally related to the duration of ozone flow. Ozonated VCO with a longer duration of ozone flow healed the wound more quickly and had the shortest wound length. VCO with ozone flow for 14 hours (16837.10 µm) had the biggest reduction in wound length compared to other groups. The wounds treated with ozonated VCO showed an increase in HSP90β, VEGF-A, EGF, bFGF and CD34 levels that correlated to improved wound healing. A longer period of treatment resulted in higher levels of wound healing biomarkers compared to shorter therapeutic durations. Conclusions: Topical ozonated VCO improved the wound healing process in a diabetic ulcer mouse model by improving macroscopic wound appearance and increasing levels of wound healing biomarkers.

This research aimed to enhance the antibacterial activity of silver nanoparticles (AgNPs) synthesized from silver nitrate (AgNO3) using aloe vera extract. It was performed by means of incorporating AgNPs on an activated carbon nanoparticle (ACNPs) under ultrasonic agitation (40 kHz, 2 × 50 watt) for 30 min in an aqueous colloidal medium. The successful AgNPs synthesis was clarified with both Ultraviolet-Visible (UV-Vis) and Fourier Transform Infrared (FTIR) spectrophotometers. The successful AgNPs–ACNPs incorporation and its particle size analysis was performed using Transmission Electron Microscope (TEM). The brown color suspension generation and UV-Vis’s spectra maximum wavelength at around 480 nm confirmed the existence of AgNPs. The particle sizes of the produced AgNPs were about 5 to 10 nm in the majority number, which collectively surrounded the aloe vera extract secondary metabolites formed core-shell like nanostructure of 8.20 ± 2.05 nm in average size, while ACNPs themselves were about 20.10 ± 1.52 nm in average size formed particles cluster, and 48.00 ± 8.37 nm in average size as stacking of other particles. The antibacterial activity of the synthesized AgNPs and AgNPs-immobilized ACNPs was 57.58% and 63.64%, respectively (for E. coli); 61.25%, and 93.49%, respectively (for S. aureus). In addition, when the AgNPs-immobilized ACNPs material was coated on the cotton and polyester fabrics, the antibacterial activity of the materials changed, becoming 19.23% (cotton; E. coli), 31.73% (polyester; E. coli), 13.36% (cotton; S. aureus), 21.15% (polyester; S. aureus).