The present review gives an overview of the various reports on properties of line and planar defects in Cu(In,Ga)(S,Se)2 thin films for high‐efficiency solar cells. We report results from various analysis techniques applied to characterize these defects at different length scales, which allow for drawing a consistent picture on structural and electronic defect properties. A key finding is atomic reconstruction detected at line and planar defects, which may be one mechanism to reduce excess charge densities and to relax deep‐defect states from midgap to shallow energy levels. On the other hand, nonradiative Shockley–Read–Hall recombination is still enhanced with respect to defect‐free grain interiors, which is correlated with substantial reduction of luminescence intensities. Comparison of the microscopic electrical properties of planar defects in Cu(In,Ga)(S,Se)2 thin films with two‐dimensional device simulations suggest that these defects are one origin of the reduced open‐circuit voltage of the photovoltaic devices. (© 2016 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)

No abstract

The present work reports on investigations of the influence of the microstructure on electronic properties of Cu(In,Ga)Se 2 (CIGSe) thin-film solar cells. For this purpose, ZnO/CdS/CIGSe stacks of these solar cells were lifted off the Mo-coated glass substrates. The exposed CIGSe backsides of these stacks were investigated by means of electron-beam-induced current (EBIC) and cathodoluminescence (CL) measurements as well as by electron backscattered diffraction (EBSD). EBIC and CL profiles across grain boundaries (GBs), which were identified by EBSD, do not show any significant changes at R3 GBs. Across non-R3 GBs, on the other hand, the CL signals exhibit local minima with varying peak values, while by means of EBIC, decreased and also increased short-circuit current values are measured. Overall, EBIC and CL signals change across non-R3 GBs always differently. This complex situation was found in various CIGSe thin films with) ratios. A part of the EBIC profiles exhibiting reduced signals across non-R3 GBs can be approximated by a simple model based on diffusion of generated charge carriers to the GBs. V C 2014 AIP Publishing LLC.

No abstract

No abstract

No abstract

No abstract

No abstract