Nonvolatile processors offer a number of desirable properties including instant on/off, zero standby power and resilience to power failures. This paper presents a fabricated nonvolatile processor based on ferroelectric flip-flops. These flipflops are used in a distributed fashion and are able to maintain system states without any power supply indefinitely. An efficient controller is employed to achieve parallel reads and writes to the flip-flops. A reconfigurable voltage detection system is designed for automatic system backup during power failures. Measurement results show that this nonvolatile processor can operate continuously even under power failures occurring at 20 KHz. It can backup system states within 7 μs and restore them within 3 μs. Such capabilities will provide a new level of support to chip-level fine-grained power management and energy harvesting applications.

Energy harvesting is gaining more and more attentions due to its characteristics of ultra-long operation time without maintenance. However, frequent unpredictable power failures from energy harvesters bring performance and reliability challenges to traditional processors. Nonvolatile processors are promising to solve such a problem due to their advantage of zero leakage and efficient backup and restore operations. To optimize the nonvolatile processor design, this paper proposes new metrics of nonvolatile processors to consider energy harvesting factors for the first time. Furthermore, we explore the nonvolatile processor design from circuit to system level. A prototype of energy harvesting nonvolatile processor is set up and experimental results show that the proposed performance metric meets the measured results by less than 6.27% average errors. Finally, the energy consumption of nonvolatile processor is analyzed under different benchmarks.

No abstract

Energy harvesting from natural environment gives range of benefits for the Internet of Things. Scavenging energy from photovoltaic (PV) cells is one of the most practical solutions in terms of power density among existing energy harvesting sources. PV power systems mandate the maximum power point tracking (MPPT) to scavenge the maximum possible solar energy. In general, a switching-mode power converter, an MPPT charger, controls the charging current to the energy storage element (a battery or equivalent), and the energy storage element provides power to the load device. The mismatch between the maximum power point (MPP) current and the load current is managed by the energy storage element. However, such architecture causes significant energy loss (typically over 20%) and a significant weight/volume and a high cost due to the cascaded power converters and the energy storage element.This paper pioneers a converter-less PV power system with the MPPT that directly supplies power to the load without the power converters or the energy storage element. The proposed system uses a nonvolatile microprocessor to enable an extremely fine-grain dynamic power management (DPM) in a few hundred microseconds. This makes it possible to match the load current with the MPP current. We present detailed modeling, simulation and optimization of the proposed energy harvesting system including the radio frequency transceiver. Experiments show that the proposed setup achieves an 87.1% of overall system efficiency during a day, 30.6% higher than the conventional MPPT methods in actual measurements, and thus a significantly higher duty cycle under a weak solar irradiance.

No abstract

No abstract

No abstract

No abstract