Artificial bone has been employed to reconstruct bone defects. However, only few reports on implant placement after block bone grafting exist. Objectives The purpose of this study was to evaluate the osseointegration of dental implant in bone reconstructions with interconnected porous calcium hydroxyapatite (IP-CHA).Material and Methods The IP-CHA cylinders (D; 4.3 mm, H; 10.0 mm) were placed into bone sockets in each side of the femurs of four male dogs. The IP-CHA on the right side was a 24-week sample. Twelve weeks after placement, a titanium implant was placed into a socket that was prepared in half of the placed IP-CHA cylinder on the right side. On the left side, another IP-CHA cylinder was placed as a 12-week sample. After another 12 weeks, the samples were harvested, and the bone regeneration and bone-implant contact (BIC) ratios were measured.Results New bone formation area was superior in the 24-week IP-CHA compared with the 12-week IP-CHA. BIC was not significantly different between IP-CHA and the parent sites. Osseointegration was detected around the implant in IP-CHA-reconstructed bone.Conclusion Our preliminary results suggest that IP-CHA may be a suitable bone graft material for reconstructing bones that require implant placement.
Objective:This study aimed to evaluate the effects of continual intermittent administration of parathyroid hormone (PTH) on implant stability in the presence of osteoporosis, using rabbit models.Material and Methods:Fifteen female New Zealand white rabbits underwent ovariectomy and were administered glucocorticoids to induce osteoporosis, following which they were divided into three groups. The first group received intermittent subcutaneous PTH for 4 weeks until implant placement (PTH1), while the second and third groups received PTH (PTH2) and saline (control), respectively, for 4 weeks before and after implant placement. After intermittent administration of PTH or saline, titanium implants were inserted into the left femoral epiphyses of all animals, and the implant stability quotient (ISQ) was measured immediately after placement to assess the primary stability and at 2 and 4 weeks after implant placement to assess osseointegration. At 4 weeks after implant placement, histological and histomorphometric evaluations were conducted and the bone area around the implant socket was measured as a ratio of the total bone area to the total tissue area.Results:Regarding primary stability, the ISQ values for the PTH1 and PTH2 groups were significantly higher than those for the control group (p<0.05). Concerning osseointegration, the ISQ values at 2 and 4 weeks were significantly higher for the PTH2 group than for the PTH1 and control (p<0.05) groups. Histological assessments showed a thicker and more trabecular bone around the implant sockets in the PTH2 specimens than in the PTH1 and control specimens. The bone area around the implant socket was significantly greater in the PTH2 group than in the PTH1 and control groups (p<0.05).Conclusions:Our results suggest that continual intermittent PTH administration before and after dental implant placement is effective for the achievement of favorable stability and osseointegration in the presence of osteoporosis.
Evaluating primary stability is important to predict the prognosis of dental implant treatment. Primary stability is decreased in a low bone density site such as osteoporosis. However, it is difficult to apply in small animal and the effect of the different implant surface topography for the primary stability at low bone density site has not yet fully been investigated. The purpose of the present study was to evaluate the influence of implant surface topography on primary stability in a standardized osteoporosis animal model. Six rabbits underwent ovariectomy and administrated glucocorticoid to induce an osteoporosis model. Sham-operations were performed in additional six rabbits. Implants with machined or oxidized-surfaces were inserted into the femur epiphyses and insertion torque (IT) and implant stability quotient (ISQ) were measured. In sham model, the IT and ISQ did not differ significantly between the both implant. However, the IT value of oxidized-surface implant was significantly higher than that of the machined implant in the osteoporosis model. Meanwhile, ISQ did not significantly differ between the machined and oxidized-surfaced implants. In conclusion, the IT of implants is higher with rough than with smooth surfaces but that there are no differences in ISQ value between different surfaces in a standardized osteoporosis bone reduced rabbit model.
The purpose of this study was to evaluate the characteristic structures and osteoconduction ability of porous titanium structures using a resin-impregnated titanium substitution fabrication technique.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.