No abstract

No abstract

High-pressure methods have become an interesting tool of investigation of structural stability of proteins. They are used to study protein unfolding, but dissociation of oligomeric proteins can be addressed this way, too. HIV-1 protease, although an interesting object of biophysical experiments, has not been studied at high pressure yet. In this study HIV-1 protease is investigated by high pressure (up to 600 MPa) fluorescence spectroscopy of either the inherent tryptophan residues or external 8-anilino-1-naphtalenesulfonic acid at 25°C. A fast concentration-dependent structural transition is detected that corresponds to the dimer-monomer equilibrium. This transition is followed by a slow concentration independent transition that can be assigned to the monomer unfolding. In the presence of a tight-binding inhibitor none of these transitions are observed, which confirms the stabilizing effect of inhibitor. High-pressure enzyme kinetics (up to 350 MPa) also reveals the stabilizing effect of substrate. Unfolding of the protease can thus proceed only from the monomeric state after dimer dissociation and is unfavourable at atmospheric pressure. Dimer-destabilizing effect of high pressure is caused by negative volume change of dimer dissociation of −32.5 mL/mol. It helps us to determine the atmospheric pressure dimerization constant of 0.92 μM. High-pressure methods thus enable the investigation of structural phenomena that are difficult or impossible to measure at atmospheric pressure.

No abstract

No abstract

No abstract

The behavior of microparticles exposed to gravitational and lift forces and to the velocity gradient in flow velocity profile formed in microfluidic conduits is studied from the viewpoint of the transient period (the relaxation) between the moment at which a particle starts to be transported by the hydrodynamic flow and the time at which it reaches an equilibrium position, characterized by a balance of all active forces. The theoretical model allowing the calculation of the relaxation time is proposed. The numerical calculus based on the proposed model is compared with the experimental data obtained under different experimental conditions, namely, for different lengths of microfluidic channels, different average linear velocities of the carrier liquid, and different sizes and densities of the particles used in the study. The results are important for the optimization of microfluidic separation units such as microthermal field-flow fractionation channels in which the separation or manipulation of the microparticles of various origin, synthetic, natural, biological, etc., is performed under similar experimental conditions but by applying an additional thermodynamic force.

Micro-Thermal Field-Flow Fractionation of polymer colloidal particles was performed in two different laboratories. Short term repeatability of the experimental retentions obtained in a single laboratory has been found to be very high. The short term precision (expressed as percent standard deviation) of the determination of average particle diameter can reach the values greater than 1%, relative. Average repeatability of the retentions in both laboratories was better than 3%, relative when using identical experimental protocol. No other method of particle size analysis can provide the results of a comparable precision. Average repeatability of the width of the raw fractograms, which contains the information on particle size distribution, is of the order of 5%, relative. However, this value cannot be considered as the ultimate limit because the experiments were not carried at the low flow rate of the carrier liquid permitted to reach much higher resolution. The effect of the stability of the most important operational variables, such as the temperature drop between the cold and hot walls, the temperature of the cold wall, and the flow rate of the carrier liquid, on the precision of the analytical results is discussed.