Abstract. In this paper we present recent achievements on developing and testing a tool to detect the composition of ambient ions in the mass/charge range up to 2000 Th. The instrument is an Atmospheric Pressure Interface Timeof-Flight Mass Spectrometer (APi-TOF, Tofwerk AG). Its mass accuracy is better than 0.002%, and the mass resolving power is 3000 Th/Th. In the data analysis, a new efficient Matlab based set of programs (tofTools) were developed, tested and used. The APi-TOF was tested both in laboratory conditions and applied to outdoor air sampling in Helsinki at the SMEAR III station. Transmission efficiency calibrations showed a throughput of 0.1-0.5% in the range 100-1300 Th for positive ions, and linearity over 3 orders of magnitude in concentration was determined. In the laboratory tests the APi-TOF detected sulphuric acid-ammonia clusters in high concentration from a nebulised sample illustrating the potential of the instrument in revealing the role of sulphuric acid clusters in atmospheric new particle formation. The APi-TOF features a high enough accuracy, resolution and sensitivity for the determination of the composition of atmospheric small ions although the total concentration of those ions is typically only 400-2000 cm −3 . The atmospheric ions were identified based on their exact masses, utilizing Kendrick analysis and correlograms as well as narrowing down the potential candidates based on their proton affinities as well isotopic patterns. In Helsinki during daytime the main negative ambient small ions were inorganic Correspondence to: H. Junninen (heikki.junninen@helsinki.fi) acids and their clusters. The positive ions were more complex, the main compounds were (poly)alkyl pyridines andamines. The APi-TOF provides a near universal interface for atmospheric pressure sampling, and this key feature will be utilized in future laboratory and field studies.

Abstract.As demonstrated in a number of investigations, gaseous sulfuric acid plays a central role in atmospheric aerosol formation. Using chemical ionization mass spectrometer the gas-phase sulfuric acid and OH concentration were measured in Hyytiälä, SMEAR II station, Southern Finland during 24 March to 28 June 2007. Clear diurnal cycles were observed as well as differences between new particle formation event days and non-event days. Typically, the daily maximum concentrations of gas phase sulfuric acid varied from 3×10 5 to 2×10 6 molec cm −3 between non-event and event days. Noon-time OH concentrations varied from 3-6×10 5 molec cm −3 and not a clear difference between event and non-events was detected. The measured time series were also used as a foundation to develop reasonable proxies for sulfuric acid concentration. The proxies utilized source and sink terms, and the simplest proxy is radiation times sulfur dioxide divided by condensation sink. Since it is still challenging to measure sulfuric acid in ambient concentrations, and due to its significant role in atmospheric particle formation, reasonable proxies are needed. We use all together three different proxies and one chemical box model and compared their results to the measured data. The proxies for the sulfuric acid concentration worked reasonably well, and will be used to describe sulfuric acid concentrations in SMEAR II station, when no measured sulfuric acid data is available. With caution the proxies could be applied to other environments as well.

The ionization mechanism in dopant-assisted atmospheric pressure photoionization and the effect of solvent on the ionization efficiency was studied using 7 naphthalenes and 13 different solvent systems. The ionization efficiency was 1-2 orders of magnitude higher with dopant than without, indicating that the photoionization of the dopant initiates the ionization process. In positive ion mode, the analytes were ionized either by charge exchange or by proton transfer. Charge exchange was favored for low proton affinity solvents (water, hexane, chloroform), whereas the addition of methanol or acetonitrile to the solvent initiated proton transfer. In negative ion mode, the compounds with high electron affinity were ionized by electron capture or by charge exchange and the compounds with high gas-phase acidity were ionized by proton transfer. In addition, some oxidation reactions were observed. All the reactions leading to ionization of analytes in negative ion mode are initiated by thermal electrons formed in photoionization of toluene. The testing of different solvents showed that addition of buffers such as ammonium acetate, ammonium hydroxide, or acetic acid may suppress ionization in APPI. The reactions are discussed in detail in light of thermodynamic data.

The study of the metabolic fate of drugs is an essential and important part of the drug development process. The analysis of metabolites is a challenging task and several different analytical methods have been used in these studies. However, after the introduction of the atmospheric pressure ionization (API) technique, electrospray and atmospheric pressure chemical ionization, liquid chromatography/mass spectrometry (LC/MS) has become an important and widely used method in the analysis of metabolites owing to its superior specificity, sensitivity and efficiency. In this paper the feasibility of LC/API-MS techniques in the identification, structure characterization and quantitation of drug metabolites is reviewed. Sample preparation, LC techniques, isotope labeling, suitability of different MS techniques, such as tandem mass spectrometry, and high-resolution MS in drug metabolite analysis, are summarized and discussed. Automation of data acquisition and interpretation, special techniques and possible future trends are also the topics of the review.

An ambient ionization technique for mass spectrometry, desorption atmospheric pressure photoionization (DAPPI), is presented, and its application to the rapid analysis of compounds of various polarities on surfaces is demonstrated. The DAPPI technique relies on a heated nebulizer microchip delivering a heated jet of vaporized solvent, e.g., toluene, and a photoionization lamp emitting 10-eV photons. The solvent jet is directed toward sample spots on a surface, causing the desorption of analytes from the surface. The photons emitted by the lamp ionize the analytes, which are then directed into the mass spectrometer. The limits of detection obtained with DAPPI were in the range of 56-670 fmol. Also, the direct analysis of pharmaceuticals from a tablet surface was successfully demonstrated. A comparison of the performance of DAPPI with that of the popular desorption electrospray ionization method was done with four standard compounds. DAPPI was shown to be equally or more sensitive especially in the case of less polar analytes.

The ionization mechanism in the novel atmospheric pressure photoionization mass spectrometry (APPI-MS) in negative ion mode was studied thoroughly by the analysis of seven compounds in 17 solvent systems. The compounds possessed either gas-phase acidity or positive electron affinity, whereas the solvent systems had different polarities and gas-phase acidities and some of them positive electron affinities. The analytes that possessed gas-phase acidity formed deprotonated ions in proton transfer; in addition, fragments and solvent adducts were observed. The compounds of positive electron affinity formed negative molecular ions by electron capture or charge exchange and substitution products of formϪ by substitution reactions. The efficiency of deprotonation was decreased if the solvent used possessed higher gas-phase acidity than the analyte. Solvents of positive electron affinity captured thermal electrons and deteriorated the ionization of all the analytes. Also, the proportion of substitution products was affected by the solvent. Finally, the performances of negative ion APPI and negative ion APCI were compared. The sensitivity for the studied compounds was better in APPI, but the formation of substitution products was lower in APCI. ( and aromatic imines and amines [8].The ionization process in dopant assisted APPI in positive ion mode is initiated by the photoionization of a dopant (e.g., toluene) and formation of a dopant radical cation [1,7,9]. Next, the dopant radical cation can ionize the solvent molecule by proton transfer, if the proton affinity (PA) of the solvent molecule is higher than that of the deprotonated radical cation. Protonated solvent molecules can donate a proton to the analyte molecule, in case the PA of the analyte is higher than that of the solvent molecule. Alternatively, the dopant radical cation can ionize the analyte directly by charge exchange, if the ionization energy of the analyte is lower than that of the radical cation. Thus, two routes of ionization are possible in positive ion APPI-charge exchange and proton transfer-the route depends on the ionization energy and proton affinity of the analyte and the solvent. Charge exchange makes ionization of non-polar compounds possible, which may not be possible by using electrospray or APCI.Preliminary results on negative ion APPI indicated that negative ions can be formed by electron capture, charge exchange, proton transfer, or substitution reactions [7]. The aim of this work is to study in detail the ionization mechanism and solvent effect in negative ion APPI. Thus, seven analytes that possess gas-phase acidity or positive electron affinity (EA) were chosen to enable different ionization mechanisms in negative ion APPI. The compounds were analyzed in 17 solvents that have different polarities and gas-phase acidities; in addition two of them have positive EAs. Also, the effect of operational parameters on formation of substitution products was studied. Finally, a comparison to negative ion APCI was made.

Using a cellulose dialysis membrane and aqueous solutions of common drugs as a proof-of-principle example, we demonstrate that solid but permeable and flexible membranes can be used as interfaces for the direct analysis of solution constituents via easy ambient sonic-spray ionization mass spectrometry. This new combination of MS techniques, herein termed EASI-MIMS, promotes droplet pick up of the analyte from the external surface of the membrane from where the analyte has selectively permeated for proper mass spectrometry characterization and quantitation. Possible application of EASI-MIMS such as the environmental analyses of effluents, on-line monitoring of fermentation and biotransformations and on-line pharmacokinetic blood analysis are discussed.

The purpose of this review is to highlight the versatility of membrane introduction mass spectrometry (MIMS) in environmental applications, summarize the measurements of environmental volatile organic compounds (VOCs) accomplished using MIMS, present developments in the detection of semi-volatile organic compounds (SVOCs) and forecast possible future directions of MIMS in environmental applications.