Sonic spray ionization is shown to create a supersonic cloud of charged droplets able to promote efficient desorption and ionization of drugs directly from the surfaces of commercial drug tablets at ambient conditions. Compared with desorption electrospray ionization (DESI), desorption sonic spray ionization (DeSSI) is advantageous since it uses neither heating nor high voltages at the spray capillary. DeSSI therefore provides a more friendly environment in which to perform ambient mass spectrometry (MS). DeSSI-MS is herein evaluated for the analysis of drug tablets, and found to be, in general, as sensitive as DESI-MS. The (high) voltage-free DeSSI method provides, however, cleaner mass spectra with less abundant solvent cluster ions and with enough abundant analyte signal for tandem mass spectrometry (MS/MS). These features may therefore facilitate the DeSSI-MS detection of low molar mass components or impurities, or both. The higher-velocity supersonic DeSSI spray also facilitates matrix penetration thus providing more homogenous sampling and longer lasting ion signals.

Using a cellulose dialysis membrane and aqueous solutions of common drugs as a proof-of-principle example, we demonstrate that solid but permeable and flexible membranes can be used as interfaces for the direct analysis of solution constituents via easy ambient sonic-spray ionization mass spectrometry. This new combination of MS techniques, herein termed EASI-MIMS, promotes droplet pick up of the analyte from the external surface of the membrane from where the analyte has selectively permeated for proper mass spectrometry characterization and quantitation. Possible application of EASI-MIMS such as the environmental analyses of effluents, on-line monitoring of fermentation and biotransformations and on-line pharmacokinetic blood analysis are discussed.

Theoretical calculations and gas-phase mass spectrometric studies were performed for the reaction of the naked (NO2+) and monosolvated (CH3NO2.NO2+) nitronium ion with several monosubstituted aromatic compounds. From these studies, we propose a general model for regioselectivity based on the single-electron transfer (SET) mechanism and an alternative mechanistic scheme for electrophilic aromatic nitration. This scheme considers the SET and the polar (Ingold-Hughes) mechanisms as extremes in a continuum pathway, the occurrence and extents of both mechanisms being governed mainly by the ability, or lack of ability, of the aromatic compound to transfer an electron to NO2+.

Low-energy collision-induced dissociation (CID) and ion ± molecule reactions with 2-methyl-1,3-dioxolane (MD) performed by pentaquadrupole (QqQqQ) mass spectrometry were applied to locate the charge site in isomeric heteroaromatic cations. The 2-, 3-, and 4-pyridyl cations are indistinguishable by CID. However, as suggested by MS 3 experiments and ab initio calculations, the 2-pyridyl cation reacts extensively with MD by a transacetalization-like mechanism to afford a bicyclic dihydrooxazolopyridyl cation. The 3-and 4-pyridyl cations, on the contrary, react predominantly with MD by proton transfer, as does the analogous phenyl cation. The 2-, 4-, and 5-pyrimidyl cations display characteristic CID behavior. In addition, the 2-pyrimidyl cation reacts extensively with MD by the transacetalization-like mechanism, whereas proton transfer occurs predominantly for the 4-and 5-pyrimidyl cations. The ions thought to be the 2-and 3-furanyl and 2-and 3-thiophenyl cations show indistinguishable CID and ion ± molecule behavior. This is most likely the result of their inherent instability in the gas phase and their spontaneous isomerization to the corresponding butynoyl and butynethioyl cations HCCHCH 2 CO and HC CHCH 2 C S . These isomerizations, which are considerably exothermic according to G2(MP2) ab initio calculations, are indicated by a series of experimental results. The ions dissociate upon CID by loss of CO or CS and undergo transacetalization with MD. Most informative is the participation of HC CHCH 2 C S in a transacetalization/dissociation sequence with replacement of sulfur by oxygen, which is structurally diagnostic for thioacylium ions. It is therefore possible to locate the charge site of the 2-pyridyl and the three 2-, 4-, and 5-pyrimidyl cations and to identify the isomeric precursors from which they are derived. However, rapid isomerization to the common HCCH-CH 2 -CO(S) ion eliminates characteristic chemical behavior that could result from different charge locations in the heteroaromatic 2-and 3-furanyl and 2-and 3-thiophenyl cations.

Radom's definition, distonic radical ions are those formally arising by ionization of diradicals or zwitterionic molecules (including ylides). These ions differ, therefore, from conventional radical ions by displaying the charge site and unpaired electron site (spin) localized mandatorily on separate atoms or group of atoms; that is, these sites are separated in all of their major resonance forms. Many conventional radical ions with a major resonance form in which charge and spin sites reside formally on the same atom or group of atoms display, however, high degree of discretionary (non-mandatory) charge-spin separation. By analogy with the metal/metalloid terminology, we propose that these distonic-like radical ions be classified as distonoid ions. Radical ions would, therefore, be divided into three sub-classes: conventional, distonic, and distonoid ions. B3LYP/6-311 ϩ G(d,p) calculations for a proof-of-principle set of radical cations are used to demonstrate the existence of many types of distonoid ions with a high degree of discretionary charge-spin separation. Reliable calculations are indispensable for probing distonoid ions, since an ion that was expected to be distonoid (by the analysis of its resonance forms) is shown by the calculations to display a characteristic conventional-ion electronic distribution. Similarly to many distonic radical ions, and in sharp contrast to a conventional radical ion (ionized 1,4-dioxane), the gas-phase intrinsic bimolecular reactivity with selective neutrals of a representative distonoid ion, ionized 2-methylene 1,3-dioxolane, is found to include dual ion-radical type reactions. (J Am

A new MIMS-derived technique, headspace membrane introduction mass spectrometry (HS-MIMS), is described for direct trace level analysis of volatile organic compounds (VOCs) in soil and other dry or wet solid matrixes. A silicone membrane interface is placed about 15 cm from the ion source, and a closed airspace (headspace) is created by connecting a toggle valve to the 1/4 in. tubing that connects the membrane interface to the ion source. For the VOC analysis, the headspace is evacuated and the solid sample vessel is heated to 90 degrees C. The VOCs are rapidly desorbed from the sample, pervaporated through the membrane, and preconcentrated for 4 min in the evacuated headspace. Then, the toggle valve is opened and the trapped VOCs are released into the ion source region of a quadrupole mass spectrometer. By electron ionization and selected-ion monitoring, a relatively sharp and intense peak is obtained and used for quantification. The HS-MIMS analysis shows excellent linearity and reproducibility and detection limits for many VOCs typically of 50-100 ng/kg (ppt).

No abstract

Flow injection analysis coupled with membrane introduction mass spectrometry (FIA-MIMS) with on-line derivatization is shown to allow fast, accurate, nearly interference-free, and sensitive (low microgram/L) quantitation of phenolic compounds in water. On-line FIA derivatization of the phenolic compounds is performed by acetic anhydride acetylation in a K2CO3-buffered alkaline medium. The phenol acetates so formed efficiently permeate a silicone membrane and are directly transferred to the mass spectrometer, in which they are analyzed with selectivity and high sensitivity via selected ion monitoring. FIA-MIMS analysis was performed for aqueous solutions of phenol, 2-methylphenol, 4-chlorophenol, 4-chloro-3-methylphenol, 2,4-dichlorophenol, and 2,4,6-trichlorophenol, and detection limits in the 0.5-20 micrograms/L (ppb) range were observed for an analytical frequency of six samples/h. FIA-MIMS for phenolic compound analysis is considerably less time-consuming and labor intensive than most chromatographic methods based on liquid-liquid extraction and preconcentration procedures and is therefore applicable for on-line and in-situ monitoring of phenols in wastewaters and in the environment. FIA-MIMS employing acetic anhydride derivatization is also virtually free of interferences since it combines chemical, membrane, and enhanced MS selectivity; hence quantitation of phenolic compounds can be performed in the presence of congeners.