No abstract

No abstract

In this paper, we discuss the influence of parameters such as type of carrier gas and NH3/HCl flow ratio on the growth of vertical GaN microstructures by selective-area growth (SAG) hydride vapor phase epitaxy (HVPE). On various strain-induced templates such as GaN/sapphire, GaN/Si, and AlN/Si, regular arrays of Ga-polar GaN microrods were properly achieved by adjusting the growth parameters. The photoluminescence and micro-Raman measurements reveal not only the crystal quality of the GaN microrods but also strain distribution. These results will give insight into the control of the morphology of GaN microrods in terms of the strain induced from templates in SAG-HVPE. The precisely controlled arrays of GaN microrods can be used for next-generation light-emitting diodes (LEDs) by realizing InGaN/GaN multi–quantum wells (MQWs) with a radial structure.

Recently, GaN, which has remarkable properties as a material for optical devices and high-power electron devices, has also attracted attention as a material for radiation detectors. We previously suggested the use of BGaN as a neutron detector material. However, the radiation detection characteristics of GaN itself are not yet adequately understood. For realizing a BGaN neutron detector, the understanding of the radiation detection characteristics of GaN, which is a base material of the neutron detector, is important. In this study, we evaluated the radiation detection characteristics of GaN. We performed I–V and energy spectrum measurements under alpha ray, gamma ray, and thermal neutron irradiations to characterize the radiation detection characteristics of a GaN diode. The obtained results indicate that GaN is an effective material for our proposed new BGaN-based neutron detector.

No abstract