Long-term sustainable development in developing countries requires researching and projecting urban physical growth and land use/land cover change (LUCC). This research fills a gap in the literature by exploring the issues of modelling coupled LUCC and urban growth, their causes, and the role of policymakers. Tabriz metropolitan area (TMA), located at north-west Iran, was chosen as a case study to design an integrated framework using four well-established methods: cellular automata (CA), Markov chains (MC), logistic regression (LR), and stepwise weight assessment ratio analysis (SWARA). Northern, north-west, and central TMA were affected the worst by urbanisation and the loss of cultivated and grassland between 1990 and 2020. The accessibility of arterial roadways and proximity to major cities influenced these changes. Three scenarios characterise LUCC dynamics: the uncontrolled growth scenario (UGS) and the historical trend growth scenario (HTGS) foresee significant loss of cultivated land and continued urban expansion above the long-term average in 2050, while the environmental protection growth scenario (EPGS) promotes sustainable development and compact urbanisation. This study's methodology can follow and investigate the coupled dynamics of LUCC and urban growth spatially and temporally.
Introduction: One of the main applications of laser in dentistry is the removal of dental caries and preparation of restorative cavities. The morphology and wettability of laser prepared surfaces are different from that of those prepared with conventional method which may affect the quality of the adhesive potential of bonding agents in these surfaces. This study aimed to assess the shear bond strength of a total-etch and self-etch adhesive system to primary tooth dentin prepared by two different energy densities of Er:YAG laser in comparison with surfaces prepared by bur. Methods: A total of 60 human primary second molars extracted for orthodontic purposes were selected and randomly divided into 3 main groups of equal (n = 20). Group A: Preparation of dentin surface by bur; group B: Preparation of dentin surface by laser with 300 mJ energy level; group C: Preparation of dentin surface by laser with 400 mJ energy level. In each of the main groups, the teeth were randomly assigned to 2 subgroups. Composite resin material was bonded with the total-etch adhesive system in subgroups A1, B1, and C1 and with the self-etch adhesive system in subgroups A2, B2, and C2. The samples were thermo-cycled, and composite restorations shear bond strength was measured in MPa. Data were analyzed using two-way analysis of variance (ANOVA), and P values less than 0.05 were considered statistically significant. Results: The highest and the lowest shear bond strength values were observed in group A2 (Preparation by bur-Composite resin material bonded by Clearfil SE Bond) and group C2 (Preparation by laser with 400 mJ energy level -Composite resin material bonded by Clearfil SE Bond), respectively. The results showed no statistically significant differences between the study subgroups (P > 0.05). Conclusion: It is concluded that in terms of shear bond strength to dentin, Single Bond and Clearfil SE Bond adhesive agents adequately perform in primary tooth dentin prepared by Er: YAG laser with energy levels of 300 and 400 mJ and frequency of 10 Hz.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.