Reduced graphene oxide (RGO) has recently gained considerable attention for use in electrochemical biosensing applications due to its outstanding conducting properties and large surface area. This report presents a novel microfluidic chip integrated with an RGO-based electrochemical immunosensor for label-free detection of an influenza virus, H1N1. Three microelectrodes were fabricated on a glass substrate using the photolithographic technique, and the working electrode was functionalized using RGO and monoclonal antibodies specific to the virus. These chips were integrated with polydimethylsiloxane microchannels. Structural and morphological characterizations were performed using X-ray photoelectron spectroscopy and scanning electron microscopy. Electrochemical studies revealed good selectivity and an enhanced detection limit of 0.5 PFU mL−1, where the chronoamperometric current increased linearly with H1N1 virus concentration within the range of 1 to 104 PFU mL−1 (R2 = 0.99). This microfluidic immunosensor can provide a promising platform for effective detection of biomolecules using minute samples.

Measurements of airborne viruses via sampling have been critical issues. Most electrostatic samplers have been assessed for bacterial aerosols or micrometer-sized viral particles; however, sampling of submicrometer-sized airborne viruses is necessary, especially because of the high probability of their staying airborne and their deposition in the lower respiratory tract. Here, we present a novel personal electrostatic particle concentrator (EPC) for gentle sampling of submicrometer airborne virus particles. Owing to the enhanced electric field designed in this EPC, the collection efficiencies reached values as high as 99.3-99.8% for 0.05-2 μm diameter polystyrene particles at a flow rate of 1.2 L/min. Submicrometer-sized MS2 and T3 virus particles were also collected in the EPC, and the concentrations relative to their respective initial suspensions were more than 10 times higher than those in the SKC BioSampler. Moreover, the recovery rate of T3 was 982 times higher in the EPC (-2 kV) than in the BioSampler at 12.5 L/min because of the gentle sampling of the EPC. Gentle sampling is desirable because many bioaerosols suffer from significant viability losses during sampling. The influence of ozone generated, applied electrostatic field, and the flow rate on the viability of the viruses will also be discussed.

The influenza virus has received extensive attention due to the recent H1N1 pandemics originating from swine. This study reports a label-free, highly sensitive, and selective electrical immunosensor for the detection of influenza virus H1N1 based on dielectrophoretically deposited single-walled carbon nanotubes (SWCNTs). COOH-functionalized SWCNTs were deposited on a self-assembled monolayer of polyelectrolyte polydiallyldimethyl-ammonium chloride (PDDA) between two gold electrodes by dielectrophoretic and electrostatic forces, which resulted in reproducible, uniform, aligned, and aggregation-free SWCNT channels (2-10 μm in length). Avidin was immobilized onto the PDDA-SWCNT channels, and viral antibodies were immobilized using biotin-avidin coupling. The resistance of the channels increased with the binding of the influenza viruses to the antibodies. These immunosensors showed linear behavior as the virus concentration was varied from 1 to 10(4) PFU ml(-1) along with a detection time of 30 min. The immunosensors with a 2 μm channel length detected 1 PFU ml(-1) of the influenza virus accurately (R(2) = 0.99) and selectively from MS2 bacteriophages. These immunosensors have the potential to become an important component of a point-of-care test kit that will enable a rapid clinical diagnosis.

Air-transmissible pathogenic viruses, such as influenza viruses and coronaviruses, are some of the most fatal strains and spread rapidly by air, necessitating quick and stable measurements from sample air volumes to prevent further spread of diseases and to take appropriate steps rapidly. Measurements of airborne viruses generally require their collection into liquids or onto solid surfaces, with subsequent hydrosolization and then analysis using the growth method, nucleic-acid-based techniques, or immunoassays. Measurements can also be performed in real time without sampling, where species-specific determination is generally disabled. In this review, we introduce some recent advancements in the measurement of pathogenic airborne viruses. Air sampling and measurement technologies for viral aerosols are reviewed, with special focus on the effects of air sampling on damage to the sampled viruses and their measurements. Measurement of pathogenic airborne viruses is an interdisciplinary research area that requires understanding of both aerosol technology and biotechnology to effectively address the issues. Hence, this review is expected to provide some useful guidelines regarding appropriate air sampling and virus detection methods for particular applications.

Despite extensive efforts toward developing antibiofilm materials, efficient prevention of biofilm formation remains challenging. Approaches based on a single strategy using either bactericidal material, antifouling coatings, or nanopatterning have shown limited performance in the prevention of biofilm formation. This study presents a hybrid strategy based on a lipid-hydrogel-nanotopography hybrid for the development of a highly efficient and durable biofilm-resistant material. The hybrid material consists of nanostructured antifouling, biocompatible polyethylene glycol-based polymer grafted with an antifouling zwitterionic polymer of 2-methacryloyloxyethyl phosphorylcholine. Based on the unique composite nanostructures, the lipid-hydrogel-nanostructure hybrid exhibits superior dual functionalities of antifouling and bactericidal activities against Gram-negative and Gram-positive bacteria, compared with those of surfaces with simple nanostructures or antifouling coatings. Additionally, it preserves the robust antibiofilm activity even when the material is damaged under external mechanical stimuli thanks to the polymeric composite nanostructure.

No abstract

No abstract

No abstract