Stable but not quite cubic
The black, photoactive phase of formamidinium (FA) perovskites, which is usually stabilized by cation alloying to avoid the formation of inactive hexagonal phases, is assumed to be cubic. High-resolution microscopy studies by Doherty
et al
. using nanoscale probes revealed that these FA-rich phases are not cubic but rather undergo slight tilting (by two degrees) of the octahedra. Black phases can have localized regions of hexagonal phases that nucleate degradation. Surface-bound ethylenediaminetetraacetic acid stabilized the tilted phase of pure FA lead triiodide against environmental degradation. —PDS
Understanding the nanoscopic chemical and structural changes that drive instabilities in emerging energy materials is essential for mitigating device degradation. The power conversion efficiency of halide perovskite photovoltaic devices has reached 25.7% in single junction and 29.8% in tandem perovskite/silicon cells 1,2 , yet retaining such performance under continuous operation has remained elusive 3 . Here, we develop a multimodal microscopy toolkit to reveal that in leading formamidinium-rich perovskite absorbers, nanoscale phase impurities including hexagonal polytype and lead iodide inclusions are not only traps for photo-excited carriers which themselves reduce performance 4,5 , but via the same trapping process are sites at which photochemical
Solar
cells and optoelectronics based on lead halide perovskites
are generating considerable interest but face challenges with the
use of toxic lead. In this study, we fabricate and characterize lead-free
perovskites based on germanium and tin solid solutions, CH3NH3Sn(1–x)Ge
x
I3 (0 ≤ x ≤
1). We show that these perovskite compounds possess band gaps from
1.3 to 2.0 eV, which are suitable for a range of optoelectronic applications,
from single junction devices and top cells for tandems to light-emitting
layers. Their thermodynamic stability and electronic properties are
calculated for all compositions and agree well with our experimental
measurements. Our findings demonstrate an attractive family of lead-free
perovskite semiconductors with a favorable band-gap range for efficient
single-junction solar cells.
Electrochemical energy storage devices that can harvest energy from the environment and store it are increasingly important to address both energy poverty in developing parts of the world, as well as powering off-grid autonomous devices. Currently, batteries or supercapacitors connected to solar cells are used for these applications, but these frequently suffer from voltage mismatches and inefficiencies in the device packaging. This paper presents an optically and electrochemically active electrode for photo-rechargeable zinc-ion capacitors using vanadium oxide nanofibers. These rely on photo-excited charge carrier separation to charge the capacitors without any external photovoltaic or electrical devices. We found that silver nanowires are better than carbon based conductive additives as they support photo-excited holes transport and provides light scattering centers that enhance visible light absorption. The proposed capacitors show a ~ 63% capacity increase under illumination, photo-recharge in 30 minutes and ~ 99% capacity retention over 4000 cycles.
Perovskite light-emitting diodes (PeLEDs) based on three-dimensional (3D) polycrystalline perovskites suffer from ion migration, which causes overshoot of luminance over time during operation and reduces its operational lifetime. Here, we demonstrate 3D/2D hybrid PeLEDs with extremely reduced luminance overshoot and 21 times longer operational lifetime than 3D PeLEDs. The luminance overshoot ratio of 3D/2D hybrid PeLED is only 7.4% which is greatly lower than that of 3D PeLED (150.4%). The 3D/2D hybrid perovskite is obtained by adding a small amount of neutral benzylamine to methylammonium lead bromide, which induces a proton transfer from methylammonium to benzylamine and enables crystallization of 2D perovskite without destroying the 3D phase. Benzylammonium in the perovskite lattice suppresses formation of deep-trap states and ion migration, thereby enhances both operating stability and luminous efficiency based on its retardation effect in reorientation.
A molecular ion (BF4(-)) substituted hybrid perovskite CH3NH3PbI(3-x)(BF4)x is synthesized. The substituted perovskite shows significant enhancement in electrical conductivity at low frequencies and improved photoresponse under AM1.5 illumination as compared to the perovskite (CH3NH3PbI3).
Two novel metal-free organic donor-p-acceptor dyes were synthesized using electron-rich 10-butyl-(2methylthio)-10H-phenothiazine as a donor and cyanoacrylic acid as an acceptor. The spectral response of the dye was tuned by introducing a vinylene thiophene p-bridge. Obtained optical and electrochemical properties of the dyes seemed to be promising in terms of employing them as light harvesters in dye-sensitized solar cells (DSCs). The efficiencies of the devices under standard AM 1.5G (100 mW cm À2 ) conditions reached 7.3% with volatile electrolyte. The differences in the photovoltaic parameters of these DSCs were explained by comparing the results of electrochemical impedance spectroscopy (EIS) measurements and transient photovoltage and photocurrent decay experiments.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.