AC Ohmic coil operation experiments with frequencies up to 10 kHz were performed on the TST-2 spherical tokamak device, and the pre-ionization process was studied in detail. The minimum loop voltage for pre-ionization was 0.4 V, which corresponds to 0.5 V m −1 at the inboard limiter. Dependences of growth rate and saturation level of the process on various parameters were obtained, and they are compared with a time-dependent 0-dimensional model based on Townsend avalanche and loss along field lines. Most of the dependences are reproduced qualitatively by the model, and quantitative differences are within a factor of several. However, the external vertical field dependence of the appearance time, which is defined as the time to observe a plasma, and the isotope effect cannot be reproduced by the model. An ambipolar diffusion state which is predicted theoretically but mitigated experimentally is discussed. It was found that secondary electron emission at the limiter surfaces is a candidate mechanism to mitigate the state.
Non-inductive plasma current start-up experiments were performed using the lower hybrid wave (LHW) on the TST-2 spherical tokamak. The density limit, observed in previous experiments using the outboard-launch antenna, disappeared after changing the plasma condition in the scrape-off layer, and the plasma current reached about 20 kA. In order to improve the LHW power deposition in the plasma core through an up-shift of the parallel wavenumber during the first pass through the plasma, a new top-launch antenna was designed, fabricated and installed. The plasma current ramp-up to 12 kA was achieved using the top-launch antenna alone in a preliminary experiment. Ray-tracing calculations using the measured plasma parameters showed a large up-shift during the first pass, satisfying the strong electron Landau damping condition in the plasma core.
Noninductive plasma startup is a critical issue for spherical tokamaks since there is not enough room to provide neutron shielding for the center solenoid. Startup using lower hybrid (LH) waves has been studied on the TST2 spherical tokamak. Because of the low magnetic field of a spherical tokamak, the plasma density needs to be kept at a very low value during the plasma current rampup so that the plasma core remains accessible to the LH waves. However, we have found that higher density was required to sustain larger plasma current. The achievable plasma current was limited by the maximum operational toroidal field of TST2. The existence of an optimum density for LH current drive and its toroidal field dependence is explained through a numerical simulation based on a ray tracing code and a Fokker-Planck solver. In order to access higher density at the same magnetic field, a toplaunch antenna was recently installed in addition to the existing outboardlaunch antenna. Increase in the density limit was observed when the power was launched from the top antenna, consistently with the numerical predictions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.