No abstract

No abstract

A dedicated ultrasonic scanner for acquiring RF echoes backscattered from the trabecular bone was developed. The design of device is based on the goal of minimizing of custom electronics and computations executed solely on the main computer processor and the graphics card. The electronic encoder-digitizer module executing all of the transmission and reception functions is based on a single low-cost field programmable gate array (FPGA). The scanner is equipped with a mechanical sector-scan probe with a concave transducer with 50 mm focal length, center frequency of 1.5 MHz and 60% bandwidth at -6 dB. The example of femoral neck bone examination shows that the scanner can provide ultrasonic data from deeply located bones with the ultrasound penetrating the trabecular bone up to a depth of 20 mm. It is also shown that the RF echo data acquired with the scanner allow for the estimation of attenuation coefficient and frequency dependence of backscattering coefficient of trabecular bone. The values of the calculated parameters are in the range of corresponding in vitro data from the literature but their variation is relatively high.

No abstract

Purpose Nowadays, the improvement of ultrasonic hyperthermia therapy is often achieved by adding hard particles to the sonicated medium in order to increase the heating efficiency. The explanation of the phenomenon of ultrasonic heating still requires testing on tissue mimicking materials (TMMs), enriched with particles of different sizes and physical properties. Our goal was to determine, by comparing their quantitative acoustic properties, which TMMs, with magnetic micro‐ or nanoparticles, convert more ultrasonic energy into heat or which of the particles embedded in the agar gel act as more effective thermal sonosensitizers. Methods We manufactured a pure agar gel and an agar gel with the addition of magnetic micro‐ or nanoparticles in two proportions of 8 and 16 mg/ml. Ultrasound quantitative techniques, the broadband reflection substitution technique and backscattered spectrum analysis were used to characterize the samples by speed of sound (SOS), frequency‐dependent attenuation, and backscattering coefficients. The integrated backscattering coefficients were also calculated. The quantitative parameters, scattering, and attenuation coefficients of ultrasound in phantoms with micro‐ and nanoparticles were estimated. Based on the attenuation and scattering of ultrasound in the samples, the ultrasonic energy absorption, which determines the heating efficiency, was evaluated. Additionally, the temperature increase during sonication of the phantoms by an ultrasonic beam was directly measured using thermocouples. Results The density of the materials with nanoparticles was higher than for the materials with microparticles with the same fractions of particles. The SOS for all materials ranged from 1489 to 1499 m/s. The attenuation in the whole frequency range (3–8 MHz) was higher for the materials with nanoparticles than for the materials with microparticles. For the materials with the lower content (8 mg/ml) of particles, the attenuation coefficient was 0.2 dB/(MHz cm). For the 16 mg/ml concentration of nanoparticles and microparticles, the attenuation coefficients were 0.66 and 0.45 dB/(MHz cm), respectively. The value of backscattering coefficient in the whole frequency range was greater for the materials with microparticles than for the materials with nanoparticles. The values of the integrated backscattering coefficient were 0.05 and 0.08 1/m for the materials with nanoparticles and 0.46 and 0.82 1/m for the materials with microparticles and concentrations of 8 and 16 mg/ml, respectively. The rates of temperature increase in the first 3 s due to ultrasonic heating were higher for the materials with nanoparticles than for the materials with microparticles. Conclusions Based on acoustical measurements, we confirmed that all materials can be used as tissue phantoms in the study of ultrasonic hyperthermia, as their properties were in the range of soft tissue properties. We found that the nanoparticle‐doped materials had greater attenuation and smaller scattering of ultrasound than the materials with microparticles,...

No abstract

No abstract

Investigation and operation of devices based on nonlinear interaction of high-intensity waves have been carried out for several decades. However, it is still a new tool to study the properties of the water environment and especially the upper layers of the seabed. This paper describes the results of tests of the new device that is intended to be applied for sounding underwater areas. The device has been designed and built in collaboration with the Department of Ultrasound of the Institute of Fundamental Scientic Researches of the Polish Academy of Sciences in Warsaw.