No abstract

No abstract

No abstract

No abstract

No abstract

The withdrawal capacity of screws in heat-treated spruce wood (Picea abies Karst.) was measured in the radial and tangential directions. Wood was heat-treated at temperatures of 150, 170, 190, 210, and 230 °C. Screw withdrawal capacity decreased as the degree of thermal modification was increased. Also, image analysis was used to measure the size of the deformed wood area around the screw, which increased with higher thermal modification temperatures. This leads to the practical recommendation that connections in heat-treated wood should be constructed with screws with larger diameters and deeper penetration. Moreover, larger spacing between screws is needed to ensure sufficient withdrawal capacity compared to non-treated wood.

No abstract

Additive manufacturing is becoming increasingly important for manufacturing end products, not just prototyping. However, the size of 3D-printed products is limited due to available printer sizes and other technological limitations. For example, making furniture from 3D-printed parts and wooden elements requires adequate adhesive joints. Since materials for 3D printing usually do not bond very well with adhesives designed for woodworking, they require special surface preparation to improve adhesion. In this study, fused deposition modelling (FDM) 3D-printed parts made of polylactic acid (PLA), polylactic acid with wood flour additive (Wood-PLA), and acrylonitrile-butadiene-styrene (ABS) polymers were bonded to wood with polyvinyl acetate (PVAc) adhesive. The surfaces of the samples were bonded as either non-treated, sanded, plasma treated, or sanded and plasma treated to evaluate the effect of each surface preparation on the bondability of the 3D-printed surfaces. Different surface preparations affected the bond shear strength in different ways. The plasma treatment significantly reduced water contact angles on all tested printing materials and increased the bond tensile shear strength of the adhesive used. The increase in bond strength was highest for the surfaces that had been both sanded and plasma treated. The highest increase was found for the ABS material (untreated 0.05 MPa; sanded and plasma treated 4.83 MPa) followed by Wood-PLA (from 0.45 MPa to 3.96 MPa) and PLA (from 0.55 MPa to 3.72 MPa). Analysis with a scanning electron microscope showed the smooth surfaces of the 3D-printed parts, which became rougher with sanding with more protruded particles, but plasma treatment partially melted the surface structures on the thermoplastic polymer surfaces.