No abstract

No abstract

No abstract

This paper emphasizes the importance of battery energy storage systems (BESS) for frequency stability in low inertia power systems. A mixed input signal is considered for the BESS control, consisting of the frequency variation and the rate of change of frequency, as a solution to deploy the BESS for providing both inertia and primary frequency control. A sensitivity analysis on the influence of each input signal and the reaction time of the BESS on the frequency control, as well as on the frequency stabilization was performed. Simulation are conducted on a two-area interconnected power system to study and validate the capability of BESS to provide virtual inertia and contribute to system frequency regulation.

Abstract:The latest technological developments are challenging for finding new solutions to mitigate the massive integration of renewable-based electricity generation in the electrical networks and to support new and dynamic energy and ancillary services markets. Smart meters have become ubiquitous equipment in the low voltage grid, enabled by the decision made in many countries to support massive deployments. The smart meter is the only equipment mandatory to be mounted when supplying a grid connected user, as it primarily has the function to measure delivered and/or produced energy on its common coupling point with the network, as technical and legal support for billing. Active distribution networks need new functionalities, to cope with the bidirectional energy flow behaviour of the grid, and many smart grid requirements need to be implemented in the near future. However there is no real coupling between smart metering systems and smart grids, as there is not yet a synergy using the opportunity of the high deployment level in smart metering. The paper presents a new approach for managing the smart metering and smart grid orchestration by presenting a new general design based on an unbundled smart meter (USM) concept, labelled as next generation open real-time smart meters (NORM), for integrating the smart meter, phasor measurement unit (PMU) and cyber-security through an enhanced smart metering gateway (SMG). NORM is intended to be deployed everywhere at the prosumer's interface to the grid, as it is usually now done with the standard meter. Furthermore, rich data acquired from NORM is used to demonstrate the potential of assessing grid data inconsistencies at a higher level, as function to be deployed in distribution security monitoring centers, to address the higher level cyber-security threats, such as false data injections and to allow secure grid operations and complex market activities at the same time. The measures are considering only non-sensitive data from a privacy perspective, and is therefore able to be applied everywhere in the grid, down to the end-customer level, where a citizen's personal data protection is an important aspect.

Solid State Transformers (SST) may become, in the near future, key technological enablers for decentralized energy supply systems. They have the potential to unleash new technologies and operation strategies of microgrids and prosumers to move faster towards a low carbon-based economy. This work proposes a paradigm change in the hierarchically and distributed operated power systems where SSTs are used to asynchronously connect the many small low voltage (LV) distribution networks, such as clusters of prosumers or LV microgrids, to the bulk power system. The need for asynchronously coupled microgrids requires a design that allows the LV system to operate independently from the bulk grid and to rely on its own control systems. The purpose of this new approach is to achieve immune and resilient by design configurations that allow maximizing the integration of Local Renewable Energy Resources (L-RES). The paper analyses from the stability point of view, through simplified numerical simulations, the way in which SST-interconnected microgrids can become immune to disturbances that occur in the bulk power system and how sudden changes in the microgrid can damp out at the Point of Common Coupling (PCC), thus achieving better reliability and predictability in both systems and enabling strong and healthy distributed energy storage systems (DESSs). Moreover, it is shown that in a fully inverter-based microgrid there is no need for mechanical or synthetic inertia to stabilize the microgrid during power unbalances. This happens because the electrostatic energy stored in the capacitors connected behind the SST inverter can be used for a brief time interval, until automation is activated to address the power unbalance for a longer term.

Technological developments are pushing for new solutions based upon massive integration of renewable electricity generation in networks already facing many challenges. This paper presents a novel approach to managing the energy transfer towards prosumers making use of smart management of local energy storage. The proposed design (including storage dimensioning) is based on several operating scenarios in which the prosumer might operate as: (i) a "load only" entity (from a grid perspective), thus exhibiting investment resiliency against regulatory changes and high energy efficiency; or (ii) a prosumer, in case regulatory opportunistic profit might be available. This can be realized within a newly proposed Uni-directional Resilient Consumer (UniRCon) architecture. The major aim of the proposed architecture is to achieve optimal self-consumption while avoiding curtailment even in a changing regulatory environment like, for example, the total lack of incentives for generation based on renewable energy sources (RES). One of the major advantages of the proposed architecture consists in the adaptability to changes in the regulatory and market environment. The term resilience is used with multiple meanings: (a) the prosumer's financial resilience against regulatory changes when investment calculations assume no-grid injections; (b) the prosumer's technical resilience, with electrical design based on standalone operation; (c) the resilience of clusters of interconnected end-user installations with enabled community-level electricity exchange, independent of the existing main grid supply; (d) the contribution to grid resilience, by enabling AC microgrid (MG) operation in island mode when large portions of the grid are formed by clusters of UniRCon prosumers (the ease of islanding segmentation of the local grid in case of emergencies). For proof of concept, three use-cases are detailed: (i) photovoltaic (PV) installations connected behind the meter; (ii) PV and storage available and controllable behind the meter; and (iii) the UniRCon architecture. The three use-cases are then compared and assessed for four near-future timelines as starting points for the investment. Numerical simulations show the attractiveness of the UniRCon solution in what concerns both system operation costs and supply resilience. Savings are expressed as opportunity savings arising from difference in tariffs while charging and discharging the storage unit and due to the avoidance of curtailment, as well as special taxes for the connection of PV (depending on regulatory environment). An extension of the UniRCon concept is presented also at community scale, with neighbourhood energy exchange inside a resilient cluster.

This paper presents a solution for integrating Electrical Vehicles in the Smart Grid through unbundled Smart Metering and Virtual Power Plant technology dealing with multiple objectives. Within this frame, EV can benefit of costeffective energy during the charging period but can also provide multiple ancillary services to the network, by wisely using their storage capability and their flexibility in coupling to the grid. Simulation of an EV providing services under a multi-objective VPP is also presented, with analysis and conclusions about the technical feasibility of such applications.