No abstract

Electric Vehicles (EVs) play a significant role in the reduction of CO2 emissions and other health-threatening air pollutants Accordingly, several research studies are introduced owing to replacing conventional gasoline-powered vehicles with battery-powered EVs. However, the ultra-fast charging (UFC) of the battery pack or the rapid recharging of the battery requires specific demands, including both: the EV battery and the influence on the power grid. In this regard, advanced power electronics technologies are emerging significantly to replace the currently existing gas station infrastructures with the EV charging stations to move from conventional charging (range of hours) to UFC (range of minutes). Among these power electronics conversion systems, the DC-DC conversion stage plays an essential role in supplying energy to the EV via charging the EV’s battery. Accordingly, this paper aims to present possible architectures of connecting multiple Dual Active Bridge (DAB) units as the DC-DC stage of the EV fast charger and study their Small-Signal Modeling (SSM) and their control scheme. These are, namely, Input-Series Output-Series (ISOS), Input-Series Output-Parallel (ISOP), Input-Parallel Output-Parallel (IPOP), and Input-Parallel Output-Series (IPOS). The control scheme for each system is studied through controlling the output filter inductor current such that the current profile is based on Reflex Charging (RC). The main contribution of this paper can be highlighted in providing generalized SSM as well as providing a generalized control approach for the Input-Series Input-Parallel Output-Series Output-Parallel (ISIP-OSOP) connection. The generalized model is verified with three different architectures. The control strategy for each architecture is studied to ensure equal power sharing, where simulation results are provided to elucidate the presented concept considering a three-module ISOS, IPOP, ISOP, and IPOS DC-DC converters.

No abstract

No abstract

To increase the adoption of electric vehicles (EVs), significant efforts in terms of reducing the charging time are required. Consequently, ultrafast charging (UFC) stations require extensive investigation, particularly considering their higher power level requirements. Accordingly, this paper introduces a hybrid multimodule DC-DC converter-based dual-active bridge (DAB) topology for EV-UFC to achieve high-efficiency and high-power density. The hybrid concept is achieved through employing two different groups of multimodule converters. The first is designed to be in charge of a high fraction of the total required power, operating at a relatively low switching frequency, while the second is designed for a small fraction of the total power, operating at a relatively high switching frequency. To support the power converter controller design, a generalized small-signal model for the hybrid converter is studied. Also, cross feedback output current sharing (CFOCS) control for the hybrid input-series output-parallel (ISOP) converters is examined to ensure uniform power-sharing and ensure the desired fraction of power handled by each multimodule group. The control scheme for a hybrid eight-module ISOP converter of 200 kW is investigated using a reflex charging scheme. The power loss analysis of the hybrid converter is provided and compared to conventional multimodule DC-DC converters. It has been shown that the presented converter can achieve both high efficiency ( and high power density (10.3 kW/L), compromising between the two other conventional converters. Simulation results are provided using the MatLab/Simulink software to elucidate the presented concept considering parameter mismatches.

No abstract

No abstract

Extensive investigations were carried out to study the emitted radiation during the E.D.M. process. It was found that radiation from the region of the gap between the electrode (tool) and the workpiece is significantly different when the following four conditions: open voltage, effective discharge (sparking), arc and short circuit occur during the E.D.M. process. The sparking condition is accompanied by a comparatively high radiation level at radio frequencies above 1 MHz. During arcing, however, although relatively low radiation takes place below 0.5 MHz, there is practically no radio frequency emission at all. However, the E.D.M. process could be monitored and optimized from the emitted radio frequency signals. The emitted radio signals could be employed to develop an adaptive control system for E.D.M. machines. The reported work includes apparatus, circuits and methods for monitoring the E.D.M. process and controlling such a process in accordance with the monitoring carried out.