The L mode and H mode density operational window in the vicinity of the density limit has been investigated with a combination of gas puff refuelling and improved fine tuning of neutral beam injection (NBI) heating power. In this way, a novel strategy is achieved by means of a parallel increase of density and heating power. As the density limit is approached, H modes degrade into L modes independently of heating power; this is in contrast to the generally accepted L to H mode threshold scaling PheatL-H varies as neB. Furthermore, contrary to the well known heating power independent Greenwald limit, the L mode density limit increases moderately with rising heating power, neDL varies as Pheat0.3+or-0.1, if a simple power law is assumed. The power dependence becomes more obvious when analysed in terms of edge densities and powers flowing across the separatrix into the scrape-off layer, nesep varies as Psep0.6+or-0.2. The corresponding H mode studies show that before an H mode quenches into an L mode the maximum achievable density (i.e. The H mode density limit) is practically independent of the heating power, as observed on many machines

No abstract

Puffing of impurities (neon, argon) and deuterium gas in the main chamber is used to feedback control the total radiated power fraction and the divertor neutral particle density simultaneously in the ASDEX Upgrade tokamak. The variation of Psep=Pheat-Prad(core) by impurity radiation during H mode shows a similar effect on the ELM behaviour as that obtained by a change of the heating power. For radiated power fractions above 90%, the ELM amplitude becomes very small and detachment from the divertor plates occurs, whilst no degradation of the global energy confinement is observed (completely detached high confinement mode). Additional deuterium gas puffing is found to increase the radiated power per impurity ion in the plasma core owing to the combined effect of a higher particle recycling rate and a lower core penetration probability. The outer divertor chamber, which is closed for deuterium neutrals, builds up a high neutral pressure, the magnitude of which is determined by the balance of particle sources and pumping. For this particular situation, the effective pumping time of neon and argon is considerably reduced, to less than 0.3 s, mainly owing to an improved divertor retention capability. The radiation characteristics of discharges with a neon driven radiative mantle are modelled using a 1-D radial impurity transport code that has been coupled to a simple divertor model describing particle recycling and pumping. The results of simulations are in good agreement with experiment

Due to the high heat flux to the target plates of present day divertor tokamaks, the use of thermally robust flush mounted Langmuir probes becomes more and more important. The surface normal of the probe defines a direction in space which is generally neither parallel nor perpendicular to the magnetic field, and the angle between these two vectors plays an important role for the physics in front of the probe. An analytic description of the sheath physics in front of a target plate is presented, and a model for the analysis of the I–V characteristics of such probes is derived therefrom. The model includes, on the one hand, considerably more physics than previous descriptions, and is, on the other hand, much simpler and more practical than numerical solutions and simulations. Subsequently the application of this model to triple probes is discussed. It will become evident that flush mounted probes can be used as reliably as domed probes to determine the plasma parameters in front of the target plates.

No abstract