In the edge plasma of the ASDEX tokamak, electrostatic fluctuations were observed with Langmuir probes and in Halpha light with high poloidal and temporal resolution. These fluctuations contribute a significant fraction to the 'anomalous' radial particle transport in the scrape-off layer (SOL). The basic properties and the dependence of the fluctuation parameters on the discharge conditions are documented. A model for an instability mechanism specific to the SOL is introduced and the experimentally observed fluctuation parameters are compared with the predictions of the linearized version of this model. For plasma temperatures above approximately 10 eV in the SOL the observed parameter dependences of the fluctuations are well reproduced by the model. By mixing length arguments the radial transport and the resulting density and pressure gradients in the SOL are estimated from the model. Their dependence on plasma temperature and density qualitatively agrees with the behaviour observed in ohmic discharges on ASDEX

The paper describes the effect of the isotopic mass on plasma parameters as observed in the ASDEX tokamak. The paper comprises Ohmic as well as L mode, H mode and H* mode scenarios. The measurements reveal that the ion mass is a substantial and robust parameter, which affects all the confinement times (energy, particle and momentum) in the whole operational window. Both core properties such as the sawtooth repetition time and edge properties such as the separatrix density change with the isotopic mass. Specific emphasis is given to the edge parameters and changes of the edge plasma due to different types of wall conditioning, such as carbonization and boronization. The pronounced isotope dependences of the edge and divertor parameters are explained by the secondary effect of different power fluxes into the scrape-off layer plasma and onto the divertor plates. Finally, the observations serve to test different transport theories. With respect to the ion temperature gradient driven turbulence, the isotope effect is also studied in pellet refuelled discharges with peaked density profiles. The results from ASDEX are compared with the results from other experiments

Density limit investigations on ASDEX have been performed under a variety of conditions: ohmically heated and neutral injection heated plasmas in H2, D2 and He have been studied in different divertor configurations, after various wall coating procedures, with gas puff and pellet fuelling, and in different confinement regimes with their characteristically different density profiles. A detailed description of the parametric dependence of the density limit, which in all cases is a disruptive limit, is given. This limit is shown to be a limit to the density at the plasma edge. Therefore, the highest densities corresponding to neRqa/Bt>30*1019 m-2.T-1 are obtained with centrally peaked ne profiles. Radiation from the main plasma at the density limit is always significantly below the total input power. The plasma disruption is due to an m=2 instability which for medium and high qa is preceded by one or more minor disruptions. In this range of qa, the disruptive instability is initiated by the occurrence of a Marfe on the high field side as a consequence of strong plasma cooling in this region. The duration of the Marfe increases with increasing distance between the plasma edge and the q=2 surface. After penetrating onto closed flux surfaces the Marfe leads to a current contraction and a subsequent destabilization of the m = 2 mode. In helium plasmas a strongly radiating, poloidally symmetric shell is observed before the density limit instead of a Marfe. An instantaneous destabilization of this mode is observed at low qa. Detailed measurements of plasma edge and divertor parameters close to the density limit indicate the development of a cold, dense divertor plasma before the disruption. Models describing the scrape-off layer and the divertor region predict an upper limit to the edge density at low divertor temperatures according to power balance considerations. Their relations to the experimental findings, especially the low field side cooling, ar

No abstract

No abstract