Tungsten was injected by means of laser ablation in both ohmic and additionally heated plasmas of the ASDEX Upgrade tokamak experiment. Spectroscopic investigations were performed in the extreme ultraviolet (EUV) wavelength region, 4 to 140 nm. Besides the quasi-continuum structure at ≈ 5 nm emitted by tungsten ions around W27+, isolated lines of tungsten were observed in the same spectral region and also in the range from 12 to 14 nm. By comparison with calculations from the HULLAC and RELAC codes, these lines could be identified as transitions of bromine to nickel-like tungsten ions. The concentration cW of tungsten after laser ablation was determined from comparisons between the total tungsten radiation PW and the calculated radiation losses. Calibration of the quasi-continuum intensity with the help of the PW measurements allows the tungsten concentration to be determined from spectroscopic observations, which are more sensitive. Both concentration measurements (quasi-continuum, PW) agree well in discharges with laser ablation. From a comparison of the intensity of the isolated lines with code results, cW could be estimated in the central region of hot, additionally heated plasmas. The lower detection limit of the spectroscopic method allows the extraction of cW during the tungsten divertor experiment of ASDEX Upgrade.

Several experiments were conducted in ASDEX Upgrade to prove the suitability of tungsten as a divertor target material under the conditions of a high density and low temperature divertor. The observed fluxes from a tungsten tile into the plasma are low, in keeping with the extremely low sputtering yields. In addition, the very favourable effect of `prompt redeposition' (redeposition during the first gyration) could be confirmed by the experiments. Cooling of the edge region by neon injection seems permissible, i.e. neon impurity sputtering did not increase the eroded fluxes of tungsten. The transport and accumulation behaviour were investigated by means of the laser blow-off technique. No accumulation effects could be observed in ohmic discharges. In discharges with NBI heating but without ICRH, strong accumulation can occur. High heat flux tests were performed on graphite tiles coated with plasma sprayed tungsten, which withstood a thermal load of 15 MW/m2 lasting 2 s as well as 1000 cycles of 10 MW/m2 for 2 s without disabling damage. Owing to the encouraging results, an experiment using a tungsten divertor is planned in ASDEX Upgrade

No abstract