Detailed observations of the impact of various process parameters on the fracture of brittle structures in low-k dielectric flip chips assembled on organic laminates using lead-free metallurgies are reported. Specifically, a simple model is first presented to evaluate the stresses transmitted to the chip back end of line structures which are susceptible to failure during the reflow at chip joining. These stresses are regulated by creep deformation, so that damage to the chip can be controlled by carefully engineering the creep properties of the solder joints. We introduce new experimental techniques to monitor the creep behaviour of the joints during the reflow. In particular, we describe the use of a laser interferometer technique to monitor the chip curvature with a high sampling rate (few Hz) throughout the reflow. It is shown that these measurements can be used to predict the likelihood of causing brittle fracture in the chip structures. Additionally, we present electron backscatter diffraction (EBSD) data for the microstructure of a large number of solder joints. Using a combination of these theoretical and experimental observations, we derive a complete phenomenology for brittle fractures in the chip during the reflow. The creep-limited stresses are a strong function of solder joint plastic strain rates, which in turn are a strong function of cooling rates during the reflow. Creep properties are also a strong function of the solder metallurgy: reducing the silver content in the SnAgCu alloys results in a higher propensity for creep and correspondingly lower stresses. Thermal treatments at high temperature, such as annealing, can affect the characteristics of the intermetallic compounds, resulting in different creep properties. These trends are observed as the limiting behaviour of the relatively large number of solder joints in typical flip chip packages, but due to the small size of the solder joints (approximately 100 µm in diameter), significant variability is observed from joint to joint in the interconnect array. We link this variability to the joint microstructure by showing that the size and orientation of the few grains generally forming these joints influence the risk to cause damage in the chip.
This article reports on the influence of nitriding treatment of titanium alloy on the tribological behaviour of amorphous carbon or graphite/Ti–6Al–4V couples. This contact was investigated in pin-on-disc geometry in an ambient atmosphere. The pins were made of amorphous carbon or graphite and the discs were made of Ti–6Al–4V, nitrided or not. The treatment of nitriding for this study was an N2–H2 plasma nitriding at a low temperature (700 °C) for 12 h. In these conditions, the top surface hardness was improved by a factor of 3. In this study, the mechanism of transfer and wear of carbon against Ti–6Al–4V, nitrided or not, has been studied with a scanning electron microscope, an optical microscope, etc. The analyses show that the nitriding of Ti–6Al–4V improves the tribological behaviour of the couples investigated. In fact, with the disc made of Ti–6Al–4V, the wear of carbon is very high and the disc is worn down at the end of the test. In contrast, after nitriding of the disc, the wear of carbon decreases, and there is a carbon film transfer on the disc. Moreover, with the nitriding of Ti–6Al–4V, the friction coefficient is stabilized, whereas without the nitriding of Ti–6Al–4V, the curve of the friction coefficient is marked by a very important increase during a short time. With the pin in graphite, the nitriding decreases the friction and increases the adhesion on the disc. Furthermore, the tests have shown that the contact temperature increases with the nitriding of Ti–6Al–4V.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.