Enteric viruses are a cause of waterborne disease worldwide, and low numbers in drinking water can present a significant risk of infection. Because the numbers are often quite low, large volumes (100-1,000 L) of water are usually processed. The VIRADEL method using microporous filters is most commonly used today for this purpose. Negatively charged filters require the addition of multivalent salts and acidification of the water sample to effect virus adsorption, which can make large-volume sampling difficult. Positively charged filters require no preconditioning of samples, and are able to concentrate viruses from water over a greater pH range than electronegative filters. The most widely used electropositive filter is the Virosorb 1MDS; however, the Environmental Protection Agency has added the positively charged NanoCeram filters to their proposed Method 1615. Ultrafilters concentrate viruses based on size exclusion rather than electrokinetics, but are impractical for field sampling or processing of turbid water. Elution (recovery) of viruses from filters following concentration is performed with organic (e.g., beef extract) or inorganic solutions (e.g., sodium polyphosphates). Eluates are then reconcentrated to decrease the sample volume to enhance detection methods (e.g., cell culture infectivity assays and molecular detection techniques). While the majority of available filters have demonstrated high virus retention efficiencies, the methods to elute and reconcentrate viruses have met with varying degrees of success due to the biological variability of viruses present in water.

Middle Eastern respiratory syndrome, an emerging viral infection with a global case fatality rate of 35.5%, caused major outbreaks first in 2012 and 2015, though new cases are continuously reported around the world. Transmission is believed to mainly occur in healthcare settings through aerosolized particles. This study uses Quantitative Microbial Risk Assessment to develop a generalizable model that can assist with interpreting reported outbreak data or predict risk of infection with or without the recommended strategies. The exposure scenario includes a single index patient emitting virus-containing aerosols into the air by coughing, leading to short-and long-range airborne exposures for other patients in the same room, nurses, healthcare workers, and family visitors. Aerosol transport modeling was coupled with Monte Carlo simulation to evaluate the risk of MERS illness for the exposed population. Results from a typical scenario show the daily mean risk of infection to be the highest for the nurses and healthcare workers (8.49 × 10 −4 and 7.91 × 10 −4 , respectively), and the lowest for family visitors and patients staying in the same room (3.12 × 10 −4 and 1.29 × 10 −4 , respectively). Sensitivity analysis indicates that more than 90% of the uncertainty in the risk characterization is due to the viral concentration in saliva. Assessment of risk interventions showed that respiratory masks were found to have a greater effect in reducing the risks for all the groups evaluated (>90% risk reduction), while increasing the air exchange was effective for the other patients in the same room only (up to 58% risk reduction).

Kartchner Caverns in Benson, AZ, was opened for tourism in 1999 after a careful development protocol that was designed to maintain predevelopment conditions. As a part of an ongoing effort to determine the impact of humans on this limestone cave, samples were collected from cave rock surfaces along the cave trail traveled daily by tour groups (200,000 visitors year-1) and compared to samples taken from areas designated as having medium (30-40 visitors year-1) and low (2-3 visitors year-1) levels of human exposure. Samples were also taken from fiberglass moldings installed during cave development. Culturable bacteria were recovered from these samples and 90 unique isolates were identified by using 16S rRNA polymerase chain reaction and sequencing. Diversity generally decreased as human impact increased leading to the isolation of 32, 27, and 22 strains from the low, medium, and high impact areas, respectively. The degree of human impact was also reflected in the phylogeny of the isolates recovered. Although most isolates fell into one of three phyla: Actinobacteria, Firmicutes, or Proteobacteria, the Proteobacteria were most abundant along the cave trail (77% of the isolates), while Firmicutes predominated in the low (66%) and medium (52%) impact areas. Although the abundance of Proteobacteria along the cave trail seems to include microbes of environmental rather than of anthropogenic origin, it is likely that their presence is a consequence of increased organic matter availability due to lint and other organics brought in by cave visitors. Monitoring of the cave is still in progress to determine whether these bacterial community changes may impact the future development of cave formations.

The methods used to concentrate enteric viruses from water have remained largely unchanged for nearly 30 years, with the most common technique being the use of 1MDS Virozorb filters followed by organic flocculation for secondary concentration. Recently, a few studies have investigated alternatives; however, many of these methods are impractical for use in the field or share some of the limitations of this traditional method. In the present study, the NanoCeram virus sampler, an electropositive pleated microporous filter composed of microglass filaments coated with nanoalumina fibers, was evaluated. Test viruses were first concentrated by passage of 20 liters of seeded water through the filter (average filter retention efficiency was >99.8%), and then the viruses were recovered using various salt-based or proteinaceous eluting solutions. A 1.0% sodium polyphosphate solution with 0.05 M glycine was determined to be the most effective. The recovered viruses were then further concentrated using Centricon Plus-70 centrifugal ultrafilters to a final volume of 3.3 (؎0.3 [standard deviation]) ml; this volume compares quite favorably to that of previously described methods, such as organic flocculation (ϳ15 to 40 ml). The overall virus recovery efficiencies were 66% for poliovirus 1, 83% for echovirus 1, 77% for coxsackievirus B5, 14% for adenovirus 2, and 56% for MS2 coliphage. In addition, this method appears to be compatible with both cell culture and PCR assays. This new approach for the recovery of viruses from water is therefore a viable alternative to currently used methods when small volumes of final concentrate are an advantage.

Germicidal ultraviolet (UV) devices have been widely used for pathogen disinfection in water, air, and on food and surfaces. Emerging UV technologies, like the krypton chloride (KrCl*) excimer emitting at 222 nm, are rapidly gaining popularity due to their minimal adverse effects on skin and eyes compared with conventional UV lamps emitting at 254 nm, opening opportunities for UV disinfection in occupied public spaces. In this study, inactivation of seven bacteria and five viruses, including waterborne, foodborne and respiratory pathogens, was determined in a thin‐film aqueous solution using a filtered KrCl* excimer emitting primarily at 222 nm. Our results show that the KrCl* excimer can effectively inactivate all tested bacteria and viruses, with most microorganisms achieving more than 4‐log (99.99%) reduction with a UV dose of 10 mJ cm−2. Compared with conventional UV lamps, the KrCl* excimer lamp exhibited better disinfection performance for viruses but was slightly less effective for bacteria. The relationships between UV sensitivities at 222 and 254 nm for bacteria and viruses were evaluated using regression analysis, resulting in factors that could be used to estimate the KrCl* excimer disinfection performance from well‐documented UV kinetics using conventional 254 nm UV lamps. This study provides fundamental information for pathogen disinfection when employing KrCl* excimers.

No abstract

The COVID-19 pandemic has accelerated the demand for alternatives to standard cleaning and disinfection practices. Continuously-acting coatings may provide an alternative to common surface treatments. A newly-developed quaternary ammonium polymer coating was applied to stainless steel coupons and evaluated for efficacy against human coronavirus 229E and SARS-CoV-2. The polymer coating reduced levels of both test viruses by greater than 99.9% relative to non-coated stainless steel coupons during a two-hour contact time.

The disinfection of high-contact surfaces is seen as an infection control practice to prevent the spread of pathogens by fomites. Unfortunately, recontamination of these surfaces can occur any time after the use of common disinfectants. We recently reported on a novel continuously active antimicrobial coating which was shown to reduce the spread of healthcare acquired infections in hospitals. We evaluated a modified coating that demonstrated a residual efficacy against viruses.The coated surfaces were found to be effective against human coronavirus (HCoV) 229E, reducing the concentration of these viruses by greater than 90% in 10 minutes and by greater than 99.9% after two hours of contact. The coating formulation when tested in suspension yielded a greater than 99.99% reduction of HCoV 229E within ten minutes of contact. This outcome presents an opportunity for controlling the transmission of COVID-19 from contaminated fomites.