As a transdermal drug delivery technology, microneedle array (MNA) has the characteristics of painless, minimally invasive, and precise dosage. This work discusses and compares the new MNA mold prepared by our group using MEMS technology. First, we introduced the planar pattern-to-cross-section technology (PCT) method using LIGA (Photolithography, Galvanogormung, Abformung) technology to obtain a three-dimensional structure similar to an X-ray mask pattern. On this basis, combined with polydimethylsiloxane (PDMS) transfer technology and electroplating process, metal MNA can be prepared. The second method is to use silicon wet etching combined with the SU-8 process to obtain a PDMS quadrangular pyramid MNA using PDMS transfer technology. Third method is to use the tilting rotary lithography process to obtain PDMS conical MNA on SU-8 photoresist through PDMS transfer technology. All three processes utilize parallel subtractive manufacturing methods, and the error range of reproducibility and accuracy is 2–11%. LIGA technology produces hollow MNA with an aspect ratio of up to 30, which is used for blood extraction and drug injection. The height of the MNA prepared by the engraving process is about 600 μm, which can achieve a sustained release effect together with a potential systemic delivery. The height of the MNA prepared by the ultraviolet exposure process is about 150 μm, which is used to stimulate the subcutaneous tissue.
This paper presents a novel MEMS-based inertial microswitch design with multi-directional compact constraint structures for improving the shock-resistibility. Its shock-resistibility in the reverse-sensitive direction to ultra-high g acceleration (~hunderds of thousands) is simulated and analyzed. The dynamic response process indicates that in the designed inertial microswitch the proof mass weight G, the whole system’s stiffness k and the gap x2 between the proof mass and reverse constraint blocks have significant effect on the shock-resistibility. The MEMS inertial microswitch micro-fabricated by surface micromachining has been evaluated using the drop hammer test. The maximum allowable reverse acceleration, which does not cause the spurious trigger, is defined as the reverse acceleration threshold (athr). Test results show that athr increases with the decrease of the gap x2, and the proposed microswitch tends to have a better shock-resistibility under smaller gap. The measured responses of the microswitches with and without constraint structure indicates that the device without constraint structure is prone to spurious trigger, while the designed constraint structures can effectively improve the shock-resistibility. In this paper, the method for improving the shock-resistibility and reducing the spurious trigger has been discussed.
This article presents a single-crystal piezoelectric energy harvester (PEH) with a trapezoidal hollow hole that can obtain high energy density at low frequency. Harvesters with a hollow structure were fabricated through a series of manufacturing processes such as thermocompression bonding, screen printing and laser cutting. Finite element analysis (FEA) and experimental results showed that using low modulus brass instead of stainless steel as the PEH substrate enhances the voltage output of the device, and the hollow design greatly increases the overall stress level and power density. In addition, the developed PEH with a trapezoidal hole obtained the best output performance; when the acceleration, resonance frequency and matched load resistance were 0.5 g, 56.3 Hz and 114 kΩ, respectively, the peak voltage was 17 V and the power density was 2.52 mW/cm3. Meanwhile, compared with the unhollowed device, the peak voltage and maximum power density of the proposed PEH were increased by 30.7% and 24.4%, respectively, and the resonance frequency was reduced by 7%. This study verified the feasibility of the optimized design through simulation and experimental comparison.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.