This work presents the results of the study of the physical, chemical, mineralogical and pozzolanic properties of the altered volcanic tuffs (AVT) that lie in the Los Frailes caldera, south of the Iberian Peninsula, and demonstrates their qualities as pozzolans for the manufacturing of mortars and pozzolanic cements of high mechanical strength. The main objective of this research is to show to what extent the AVTs can replace portland cement (PC) in mortars, with standardised proportions of 75:25% and 70:30% (PC-AVT). To achieve these objectives, three AVT samples were studied by a petrographic analysis of thin section (PATS), DRX, FRX and MEB. The pozzolanic properties were determined by three methods: electrical conductivity (ECT), chemical pozzolanicity tests (CPT) at 8 and 15 days and mechanical strength tests (MS) of the specimens at 2, 7, 28 and 90 days. Studies of a PATS, DRX, FRX and MEB showed that the AVT samples’ constitutions are complex where smectite (montmorillonite), mordenite, quartz, halloysite, illite, kaolinite, volcanic glass and lithic fragments coexist. The results of the ECT and CPT tests confirmed the pozzolanic properties of the samples analysed and proved an increase in mechanical strength from 2 to 90 days of testing.
This work deals with anomalous concentrations of natural mordenite in the southeast of Spain. The X-ray diffraction (XRD) and scanning electron microscopy (SEM) studies evidenced that the samples contain mainly monomineral zeolitic phase of mordenite (70% to 74%), usually accompanied by smectite (montmorillonite), the principal component of bentonite. A study of the applicability of these zeolites is presented to establish the potential use as pozzolanic cements. For comparative purposes, synthetic commercial mordenite is also characterized and tested. The initial mixtures were prepared using cement and mordenite at a 75:25 ratio. Chemical analysis and a pozzolanicity test showed the high pozzolanic character. These mixtures were further added to sand and water, yielding the cement specimens to be used as concrete. Mechanical test results showed that the mechanical compression at 7 and 28 days fall into the range of 19.23 to 43.05 MegaPascals (MPa) for the cement specimens built with natural mordenites. The obtained results fall in the same range of cement specimens prepared with natural clinoptilolite, using mixtures within the European requirement for commercial concretes. Thus, these results and the low cost of natural mordenite of San José de los Escullos deposit supports the potential use of natural mordenite as pozzolanic cement.
This work aims to study the relationship between the compression resistance and velocity from ultrasonic pulses in samples of mortars with 25% of pozzolanic content. Pozzolanic cement is a low-priced sustainable material that can reduce costs and CO2 emissions that are produced in the manufacturing of cement from the calcination of calcium carbonate. Using ultrasonic pulse velocity (UPV) to estimate the compressive resistance of mortars with pozzolanic content reduces costs when evaluating the quality of structures built with this material since it is not required to perform an unconfined compression test. The objective of this study is to establish a correlation in order to estimate the compression resistance of this material from its ultrasonic pulse velocity. For this purpose, we studied a total of 16 cement samples, including those with additions of pozzolanic content with different compositions and a sample without any additions. The results obtained show the mentioned correlation, which establishes a basis for research with a higher number of samples to ascertain if it holds true at greater curing ages.
In recent decades, large amounts of construction and demolition waste (CDW) have been generated and accumulated throughout Europe, which is a challenge to manage and control nowadays. This work shows the results of a study carried out with samples of ceramic recycled aggregates (CRAs) and recycled concrete aggregates (RCAs) mixed with cement (C) in mortars. The main objective of this research is to demonstrate how, by adding CRAs and RCAs to a mixture of cement and natural aggregate (NA), it is possible to develop a high-strength mortar and achieve the best mixing ratio. To achieve these objectives, the characterization of the samples was initially carried out such as XRF, XRD and SEM. Next, tests were carried out on the products obtained, such as the consistency of the fresh mortar and the density of the specimens. Finally, a study of mechanical compressive strength was performed at 7, 28 and 200 days. The results show that although both CRAs and RCAs negatively affect the curing process of the specimens, it is possible to develop mortars with compressive strengths greater than 20 MPa. An obvious increase in mechanical compressive strengths was seen between 7 and 200 days of analysis. The results achieved in this research could be an important guide for the management of CDWs by local industries, thus favouring the development of the circular economy.
The eruption of the Cumbre Vieja volcano on 19 September 2021, resulted in the deposition of large quantities of volcanic ash (VA), causing a great impact on the citizens. This work aims to study the properties of this volcanic ash as pozzolanic raw materials to establish their potential use in the development of sustainable cement. Results of chemical and technical characterization are presented. To achieve this goal, Ordinary Portland Cement (OPC) was replaced with standardized percentages of OPC/VA: 10, 25, and 40%. Characterization studies were carried out using chemical analysis of X-ray fluorescence (XRF), chemical quality analysis (QCA), pozzolanicity test (PT) at 8 and 15 days, as well as determining the mechanical strength (MS) at 7, 28, and 90 days. The results obtained by XRF and QCA established that the chemical composition of the VA corresponds to that of the natural pozzolan typical of pyroclastic genesis. The PT test showed that the analyzed samples have a marked pozzolanic nature, both at 8 and 15 days, showing a significant increase in their hydraulic reactivity. Likewise, the MS tests confirmed a continuous increase in mechanical compressive strength, which increased significantly from 7 to 90 days of curing, reaching more than 58 MPa. On the other hand, mechanical tests showed that the three types of dosages used OPC/VA: 10, 25, and 40% were equally effective, with OPC/VA formulations: 10–25% being the most effective. The results obtained in this research could be used by local industries as a guide for the correct use of the volcanic materials of this island, both for the manufacture of construction materials, such as aggregates, and to produce pozzolanic cement with low CO2 emissions, thus having a positive impact on the environment. Finally, the great natural availability of natural VAs in the surrounding areas of La Palma could cover part of the needs for materials used in the construction and restoration of houses and infrastructures damaged during the volcanic eruption.
The speed at which climate change is happening is leading to a demand for new pozzolanic materials that improve the quality of cements and, at the same time, limit the emission of greenhouse gases into the atmosphere. The main objective of this work is the detailed characterization of an ignimbrite sample (IGNS) to demonstrate its effectiveness as a natural pozzolan. To meet this objective, a series of tests were carried out. In the first stage, mineral and chemical analyses were performed, such as petrographic analysis by thin section (TSP), X-ray diffraction (XRD), oriented aggregate (OA), scanning electron microscopy (SEM) and X-ray fluorescence (XRF). In the second stage, the following technical tests were carried out: chemical quality analysis (QCA), pozzolanicity test (PT) and mechanical compressive strength (MS) at 7, 28 and 90 days, using mortar specimens with ignimbrite/cement formulation (IGNS/PC): 10, 25 and 40% to establish the pozzolanic nature of the ignimbrite. The results of the mineral and chemical analyses showed that the sample has a complex mineralogical constitution, consisting of biotite mica, potassium feldspar, plagioclase, smectite (montmorillonite), quartz, volcanic glass, iron, titanium and manganese oxides, chlorite and chlorapatite. On the other hand, the technological tests revealed the pozzolanic nature of the sample, as well as visible increases in the mechanical compressive strengths in the three proportions, the most effective being IGNS/PC:10% and IGNS/PC:25% at 7, 28 and 90 days of setting. The results obtained could be applied in the formulation of new pozzolanic cements with ignimbrite as a natural pozzolanic aggregate.
University students face situations throughout their careers that are sometimes difficult to overcome due to their lack of experience or preparation. Mentoring programs in university education have been proven to be a great accompaniment tool to solve these difficulties in addition to helping students’ personal and professional development. Our study aimed to show the complete mentoring process that accompanies students in the most crucial stages of their university education at the School of Mines and Energy of Universidad Politécnica de Madrid. Three stages of interest were identified in which mentoring projects have been implemented through training activities at the Unit of Social Entrepreneurship, Ethics and Values in Engineering (UESEVI). At the beginning of their studies, two welcome actions are offered: Mentor and Monitor projects that provide administrative and academic support; during the development of their studies, the Mentoring with Energy project offers professional tutoring that helps students in their incorporation into the labor market and provides them with tools to select a specialty; and in the last stage, professional accompaniment is provided by the Gray Angels project that helps students to develop their future careers. The activities of UESEVI are a strategy in our School to guarantee the development of soft skills and compliance with quality education processes. The usefulness of these programs can be measured through the participation and interest of the students. A positive evolution of these projects has been observed over the years. They have been growing according to the demand and needs detected in the successive evaluations of the programs.
This paper shows the results of a study focused on the evolution and properties of mortars made with a mixture of portland cement (PC) and natural mordenite (Mor). To begin, samples of mordenite, cement and sand were studied with X-ray diffraction (XRD), X-ray fluorescence (XRF) and granulometric analysis (GA). Next, mortars with a ratio of 75% PC and 25% mordenite were prepared to determine their initial and final setting times, consistency and density. Continuing, the density, weight and compressive strength of the specimens were determined at 2, 7, 28, 90 and 365 days. Finally, the specimens were studied using SEM, XRD and XRF. The results of the study of the mordenite sample showed a complex constitution where the major mineral component is mordenite, and to a lesser degree smectite (montmorillonite), halloysite, illite, mica, quartz, plagioclase and feldspar, in addition to altered volcanic glass. Tests with fresh cement/mordenite mortar (CMM) showed an initial setting time of 320 min and a final setting time of 420 min, much longer than the 212–310 min of portland cement mortar (PCM). It was established that the consistency of the cement/mordenite mortar (CMM) was greater than that of the PCM. The results of the density study showed that the CMM has a lower density than the PCM. On the other hand, the density of cement/mordenite specimens (CMS) was lower than that of portland cement specimens (PCS). The CMS compressive strength studies showed a significant increase from 18.2 MPa, at 2 days, to 72 MPa, at 365 days, with better strength than PCS at 28 and 365 days, respectively. XRD, XRF and SEM studies conducted on CMS showed a good development of primary and secondary tobermorite, the latter formed at the expense of portlandite; also, ettringite developed normally. This work proves that the partial replacement of PC by mordenite does not have a negative effect on the increase in the mechanical strength of CMS. It indicates that the presence of mordenite inhibits the spontaneous hydration of C3A and controls the anomalous formation of ettringite (Ett). All this, together with the mechanical strength reported, indicates that mordenite has a deep and positive influence on the evolution of the mortar setting and is an efficient pozzolan, meaning it can be used in the manufacture of mortars and highly resistant pozzolanic cement, with low hydration heat, low density, stability in extremely aggressive places and a low impact on the environment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.