The spatial structure of a low-frequency atmospheric-pressure glow discharge was studied experimentally. The radial current distribution and discharge light emission were simultaneously measured at different phases during the ac voltage cycle. The glow discharge is formed by a radially propagating ionization wave. We also observed discharge regimes with several current pulses per half cycle corresponding to the successive, spatially separated breakdowns.
Langmuir probe measurements of the temporal behavior of the electron distribution function in a low-pressure inductive discharge are presented. The structure of the measured distribution functions suggests that the loss of high energetic electrons to the wall of the discharge chamber is the main energy loss mechanism. Electron-heavy-particle collisions play only a secondary role for the energy loss. The rapid loss of energetic electrons--while low energy electrons remain confined in the space charge potential field--leads to a fast cooling of the electron distribution function. We also present a simple model to describe the evolution of the mean kinetic energy and plasma potential on the basis of a distribution function that is cutoff at energies above the potential electron energy at the wall.
A self-consistent model of capacitively coupled low-pressure rf discharge is formulated. The non-local mechanism of electron heating is considered under simple assumption about the plasma density profile. The transition of electron heating from the plasma body to electrode sheaths is observed. The criterion of a heating mode transition is formulated and expressed in terms of external discharge parameters. The asymptotic solutions for low-and high-current regimes are obtained. The comparison of calculation results with experimental data demonstrates the validity of the proposed model for a wide range of discharge conditions.
Experimental study of spatial and temporal evolution of a dielectric barrier discharge (DBD) during a single current pulse is reported. The discharge light emission has been imaged using a high-speed intensified charge-coupled device camera. The time-resolved light emission data have been combined with the discharge current and applied voltage waveforms measurements. The discharge behavior has been found to be dependent on the external circuit impedance and bandwidth. Being nonstationary in principle, the DBD can exhibit both time evolution and development over the electrode area. For a typical DBD setup with flat parallel electrodes, the discharge breakdown occurs in the electrode’s central part; then, the plasma column expands to the electrode’s peripheries and gradually fills up the entire electrode area. The powering system should be able to provide enough current value during the discharge glow to achieve a simultaneous breakdown over the whole electrode area. In this case, the discharge appears over the entire electrode’s area and the plasma column exhibits temporal evolution only. The measured discharge characteristics for different power supply architectures had shown the evidence of a “normal current density” effect in DBD glow.
In this work we present experimental results concerning electrode sheath and ion flux formation near a concave electrode with the dimension of a cavity comparable to the electrode sheath length. It is shown that the secondary electron emission can play a crucial role in plasma molding over the electrode surface. It is also observed that plasma has a tendency to "self-leakage" in electrode cavities.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.