Development of a precise and delicate reaction has been acquired for the determination of vancomycin hydrochloride using batch and cloud point extraction (CPE) methods. The first method is based on the formation of azo dye as a result of diazotized dapsone coupled with vancomycin HCl (VAN) in a basic medium. The sensitivity of this reaction was enhanced by utilizing a nonionic surfactant (Triton X-114) and the cloud point extraction technique (second method). The azo dye formed was extracted into the surfactant-rich phase, dissolved in ethanol and detected at λ max 446 nm spectrophotometrically. The reaction was investigated using both batch and CPE methods (with and without extraction), and a simple comparison between the two developed methods was made. The conditions that affect the extraction process and the sensitivity of the methods have been carefully examined. The linearity of the calibration curves was in the range of 3-50 and 0.5-25 µg.mL -1 with limits of detection of 0.806 and 0.214 µg.mL -1 for VAN in both batch and CPE procedures, respectively. The percentage of relative standard deviation (R.S.D.%) for the two methods was better than 2.54% and 2.83%, respectively. The recommended procedures have been effectively used to assay VAN in commercial injections.

New, simple and sensitive batch and Flow-injecton spectrophotometric methods for the determination of Thymol in pure form and in mouth wash preparations have been proposed in this study. These methods were based on a diazotization and coupling reaction between Thymol and diazotized procaine HCl in alkaline medium to form an intense orange-red water-soluble dye that is stable and has a maximum absorption at 474 nm. A graphs of absorbance versus concentration show that Beer’s law is obeyed over the concentration range of 0.4-4.8 and 4-80 µg.ml-1 of Thymol, with detection limits of 0.072 and 1.807 µg.ml-1 of Thymol for batch and FIA methods respectively. The FIA procedure sample throughput was 80 h-1. All different chemical and physical experimental parameters that affecting on the development and stability of the colored product were carefully studied and the proposed methods were successfully applied to the determination of Thymol in mouth wash preparations.

Simple and sensitive kinetic methods are described for the determination of chloramphenicol in pure form and pharmaceutical preparations. The methods are based on oxidativecoupling reaction between reduced chloramphenicol (by zinc powder and concentrated hydrochloric acid) with promethazine hydrochloride in the presence of sodium periodate yielding a highly colored product at room temperature, the reaction is followed spectrophotometriclly at λ max = 590 nm. Initial rate and fixed time (at 20 minutes) methods are utilized for concentration determination. The calibration graphs were linear in the concentration ranges (2-20 µg.ml-1) and (0.5-30 µg.ml-1) respectively. The results were validated statistically and checked through recovery studies, and have been applied successfully for the determination of chloramphenicol in commercial dosage forms.

Background: Tetracycline is one of the most important antibiotics. It is used to treat many different bacterial infections. It is often used in treating severe acne, or sexually transmitted diseases such as syphilis, gonorrhea, or chlamydia. In some cases, tetracycline is used when penicillin or another antibiotic cannot be used to treat serious infections such as the ones caused by Bacillus anthracis, Listeria, Clostridium, Actinomyces. Aim: synthesized a new novel reagent used to determine TCH spectrophotometrically by using diazonium and coupling reaction. Methods: Four new substituted procaine derivatives were prepared by simple organic methods using aniline derivatives. A spectrophotometric approach was established for the micro-determination of TCH. The stoichiometry was investigated using mole ratio and continuous variation methods, and the stability constant was also estimated. The ΔG, ΔH, and ΔS were determined as thermodynamic parameters for evaluating the effect of temperature on the reaction. Results: Substituted procaine derivatives were prepared, and o-hydroxy procaine seems to be the best reagent used to determine TCH by diazotization and coupling reaction. The result was a yellow water-soluble dye with a maximum absorbance of 380 nm. The reaction conditions were studied and optimized. Beers law was obeyed over a concentration range (2.5–50) μg.mL-1 for TCH. The molar absorptivity was (14.4669.103) L.mol-1.cm-1, and the detection limit was (0.5052) μg.mL-1. The stoichiometry of the formed product was found 1:1 (o-hydroxyprocaine: TCH). The stability constant indicated that the product formed was stable, and the thermodynamic parameters showed that the diazonium salt reaction was preferred to occur at a low temperature. Conclusions: a simple, accurate, and fast method was developed to determine TCH in pure form and pharmaceuticals by coupling the TCH with a newly synthesized procaine derivative reagent (o-hydroxy procaine) in a basic medium.