Synthesized GDP shows strong antimicrobial activity against P. acnes in vitro. The clinical improvement observed suggests a topical formulation containing the GDP has therapeutic potential for the improvement of inflammatory-type acne vulgaris by its antimicrobial activity.
This paper proposes a junction temperature estimation algorithm for the insulated gate bipolar transistor (IGBT) based on a power loss calculation and a thermal impedance model for inverter systems. The Simulink model was designed to calculate the power losses of power semiconductor devices and to estimate the junction temperature with a simplified thermal impedance model. This model can estimate the junction temperature up to the transient state, including the steady state. The parameters used to calculate the power losses, the thermal resistance, and the thermal capacitance were optimized for a given inverter to be tested for improving the accuracy. The simulation results and experimental measurement data were compared to verify the proposed junction temperature estimation algorithm. Finally, the algorithm was installed on the inverter controller, and the performance was verified by comparing the real time estimation result with the measured temperature.
Two algorithms have been extensively studied for motor control: Field Oriented Control (FOC) and Direct Torque Control (DTC). Both control algorithms use a Voltage Source Inverter (VSI) to drive a Permanent Magnet Synchronous Motor (PMSM). To prevent short-arm short-circuit accidents when driving PMSM using VSI, a dead time is used to turn off the TOP and BOTTOM switches of each arm at the same time. However, this dead-time technique causes an unexpected pole voltage to be applied to the PMSM on the VSI output voltage, causing distortion and resulting in control nonlinearity. The disturbance voltage that causes nonlinearity is difficult to measure directly with the sensor. Therefore, this paper analyzes the nonlinearity of the controller due to the distorted voltage caused by the dead time during PMSM operation using the DTC algorithm and predicts the distorted output voltage using the extended Kalman Filter (EKF) to improve control stability. As a result, The algorithm proposed in this paper has verified the improvement of torque ripple and stator flux ripple through experiments and simulations.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.