Opportunistic screening for osteoporosis can be performed using low‐dose computed tomography (LDCT) imaging obtained for other clinical indications. In this study we explored the CT‐derived bone mineral density (BMD) and prevalence of osteoporosis from thoracic LDCT in a large population cohort of Chinese men and women. A total of 69,095 adults (40,733 men and 28,362 women) received a thoracic LDCT scan for the purpose of lung cancer screening between 2018 and 2019, and data were obtained for analysis from the China Biobank Project, a prospective nationwide multicenter population study. Lumbar spine (L1–L2) trabecular volumetric bone mineral density (vBMD) was derived from these scans using quantitative computed tomography (QCT) software and the American College of Radiology QCT diagnostic criteria for osteoporosis were applied. Geographic regional differences in the prevalence of osteoporosis were assessed and the age‐standardized, population prevalence of osteoporosis in Chinese men and women was estimated from the 2010 China census. The prevalence of osteoporosis by QCT for the Chinese population aged >50 years was 29.0% for women and 13.5% for men, equating to 49.0 million and 22.8 million, respectively. In women, this rate is comparable to estimates from dual‐energy X‐ray absorptiometry (DXA), but in men, the prevalence is double. Prevalence varied geographically across China, with higher rates in the southwest and lower rates in the northeast. Trabecular vBMD decreased with age in both men and women. Women had higher peak trabecular vBMD (185.4 mg/cm3) than men (176.6 mg/cm3) at age 30 to 34 years, but older women had lower trabecular vBMD (62.4 mg/cm3) than men (92.1 mg/cm3) at age 80 years. We show that LDCT‐based opportunistic screening could identify large numbers of patients with low lumbar vBMD, and that future cohort studies are now required to evaluate the clinical utility of such screening in terms of fracture prevention and supporting national health economic analyses. © 2020 The Authors. Journal of Bone and Mineral Research published by Wiley Periodicals LLC on behalf of American Society for Bone and Mineral Research (ASBMR)..

Since a novel coronavirus was discovered from a cluster of patients with emerging pneumonia of unknown etiology in Wuhan, China, it has spread rapidly through droplet and contact transmission. Recently, the novel coronavirus pneumonia which was named COVID-19 by the World Health Organization (WHO) has been raised as a worldwide problem. Radiological examinations were confirmed as effective methods for the screening and diagnosis of COVID-19. It is reported that some radiologists and radiological technologists were infected when giving examinations to the patients with COVID-19. In order to reduce the infection risk of medical staff in radiology department, we summarized the experience on prevention and control measures in radiology department for COVID-19, aiming to guide the prevention and practical work for radiologists and radiological technologists. Key Points • The novel coronavirus spreads rapidly through droplet and contact transmission.• Radiologists and radiological technologists were possibly infected by patients.• Prevention and control measures in radiology department for COVID-19 are important.

Background: Osteoporosis, obesity, and fatty liver are increasingly common chronic diseases that seriously threaten people's health. Low-dose chest computed tomography (LDCT) scan is frequently used for lung cancer screening in health screenings and checkups. Quantitative computed tomography (QCT) enables the accurate measurement of volumetric bone mineral density (vBMD), liver fat content, and abdominal fat area using the existing LDCT data without extra radiation. We initiated a new project, the China Health Big Data (China Biobank) , which combines the LDCT scan images from lung cancer screening of participants in health checkup with QCT to investigate the added value of QCT to LDCT, in order to establish the normative reference database and diagnosis criteria for the three aforementioned conditions. Methods: The China Biobank project is a prospective nationwide multicenter cohort study that will combine QCT technology with LDCT scans to measure bone mineral density (BMD), intra-abdominal fat distribution, and liver fat content of the generally healthy checkup participants. Mindways QCT calibration phantom (Mindways Software Inc., Austin, TX, USA) and analysis software QCT PRO v6.0 will be used for all centers. Before data collection begins, the European Spine Phantom (ESP) will be used for quality control analysis at each collaborating center. The inclusion criteria are a healthy checkup participant aged 30-90 years, with LDCT as a part of his/her health checkup protocol. Exclusion criteria are pregnant women or participants with a metal implant in the CT scan area. The LDCT images will be transferred to the Mindways workstation for analysis, and vBMD in the L1 and L2 vertebrae, visceral adipose tissue (VAT), subcutaneous adipose tissue (SAT), and liver fat content will be measured. As part of the health checkup, the demographic, anthropometric parameters, blood pressure, and a routine blood laboratory test will be collected. The estimated sample size will be about 30,000. Results: The combination of QCT with LDCT of the chest is validated in this project. The vBMD of spine, visceral fat and liver fat can be measured with a LDCT chest scan. Conclusions: The China Biobank project will assess the added value of QCT to LDCT, and enable accurate evaluation of the prevalence of osteoporosis, obesity, and fatty liver disease in a very large Chinese cohort.

No abstract

No abstract

No abstract