No abstract

Inter-laboratory comparison of nanoparticle size measurements using dynamic light scattering and differential centrifugal sedimentation. NanoImpact, (2018).

Flavonoids and other benzopyrone substances, having an appropriate hydroxylation profile, may inhibit the metalloenzymes leucine aminopeptidase (LAP), aminopeptidase M (AP-M), and carboxypeptidase A (CP-A). A structural feature that evidently favours the interaction between flavonoids and the three metalloenzymes is the 2,3-double bond conjugating the A and B rings and conferring a planar structure. This can be considered virtually indispensable for inhibition of the three metallopeptidases, though the hydroxylation profile required differed for each of the enzymes, and the interaction mechanism and behaviour also differed. The inhibitory effect of flavonoids on LAP was reversible, and to be effective the flavonoid had to have conjugated A and B rings and ortho-dihydroxylation on at least one of the aromatic rings. This same requirement was essential for inhibition by coumarins and was attributed to a catechol-like mechanism of interaction. The inhibitory effects on AP-M were due to inactivation of the enzyme, irreversibly altered by flavonoids with a 2,3-double bond and a minimum of one hydroxyl substituent on each of the aromatic rings. With CP-A, conjugation of the A and B rings enhanced the inhibitory effect of flavonoids, though it was not strictly required. The interaction between the polyphenolic substances tested and the two zinc aminopeptidases was not reversed by adding zinc to the reaction medium, indicating that the inhibition is not due to the coordination of the phenolic hydroxyl groups with the catalytical zinc of active site, though the presence of zinc affected the interaction behaviour differently according to each substance's hydroxylation profile.

No abstract

Reactive oxygen species play a key role in cell signalling and oxidative stress mechanisms, therefore, sensing their production by living organisms is of fundamental interest. Here we describe a novel biosensing method for extracellular detection of endogenous hydrogen peroxide (H2O2). The method is based on the enhancement of the optical absorption spectrum of the hemoprotein cytochrome c when loaded into a highly scattering random medium. Such a configuration enables, in contrast to existing techniques, non-invasive and dynamic detection of the oxidation of cyt c in the presence of H2O2 with unprecedented sensitivity. Dynamic information on the modification of the cell oxidative status of Chlamydomonas reinhardtii, an aquatic green algae, was obtained under oxidative stress conditions induced by the presence of trace concentrations of Cd(II). Furthermore, the dynamics of H2O2 production was investigated under different lighting conditions confirming the impact of Cd(II) on the photosynthetic activity of those phytoplanktonic cells.

A multiplexed immunoassay-based antibiotic sensing device integrated in a lab-on-a-chip format is described. The approach is multidisciplinary and involves the convergent development of a multiantibiotic competitive immunoassay based on sensitive wavelength interrogated optical sensor (WIOS) technology and a polymer-based self-contained microfluidic cartridge. Immunoassay solutions are pressure-driven through external and concerted actuation of a single syringe pump and multiposition valve. Moreover, the use of a novel photosensitive material in a 'one step' fabrication process allowed the rapid fabrication of microfluidic components and interconnection port simultaneously. Pre-filled microfluidic cartridges were used as binary response rapid tests for the simultaneous detection of three antibiotic families -sulfonamides, fluoroquinolones and tetracyclines -in raw milk. For test interpretation, any signal lower than the threshold value obtained for the corresponding Maximum Residue Limit (MRL) concentration (100 mg L À1 ) was considered negative for a given antibiotic. The reliability of the multiplexed detection system was assessed by way of a validation test carried out on a series of six blind milk samples. A test accuracy of 95% was calculated from this experiment. The whole immunoassay procedure is fast (less than 10 minutes) and easy to handle (automated actuation).

a b s t r a c tA novel third generation biosensor was developed based on one-shot adsorption of chemicallymodified cytochrome c (cyt c) onto bare gold electrodes. In contrast to the classic approach which consists of attaching cyt c onto an active self-assembled monolayer (SAM) priory chemisorbed on gold, here short-chain thiol derivatives (mercaptopropionic acid, MPA) were chemically introduced on cyt c protein shell via its lysine residues enabling the very fast formation (o 5 min) of an electroactive biological self-assembled monolayer (SAM) exhibiting a quasi-reversible electrochemical behavior and a fast direct electron transfer (ET). The heterogeneous ET rate constant was estimated to be k s ¼ 1600 s, confirming that short anchors facilitate the ET via an efficient orientation of the heme pocket. In comparison, no ET was observed in the case of native and long-anchor (mercaptoundecanoic acid, MUA) modified cyt c directly adsorbed on gold. However, in both cases the ET was efficiently restored upon in-bulk generation of gold nanoparticles which acted as electron shuttles. This observation emphasizes that the lack of electroactivity might be caused by either an inappropriate orientation of the protein (native cyt c) or a critical distance (MUA-cyt c). Finally, the sensitivity of the bare gold electrode directly modified with MPA-cyt c to hydrogen peroxide (H 2 O 2 ) was evaluated by amperometry and the so-made amperometric biosensor was able to perform real-time and noninvasive detection of endogeneous H 2 O 2 released by unicellular aquatic microorganisms, Chlamydomonas reinhardtii, upon cadmium exposure.

The present work describes a methodology for patterning biomolecules on silicon-based analytical devices that reconciles 3-D biological functionalization with standard resist lift-off techniques. Unlike classic sol-gel approaches in which the biomolecule of interest is introduced within the sol mixture, a two-stage scenario has been developed. It consists first of patterning micrometer/submicrometer polycondensate scaffold structures, using classic microfabrication tools, that are then loaded with native biomolecules via a second simple incubation step under biologically friendly environmental conditions. The common compatibility issue between the biological and microfabrication worlds has been circumvented because native recognition biomolecules can be introduced into the host scaffold downstream from all compatibility issues. The scaffold can be generated on any silicon substrate via the polycondensation of aminosilane, namely, aminopropyltriethoxy silane (APTES), under conditions that are fully compatible with resist mask lithography. The scaffold porosity and high primary amine content allow proteins and nucleic acid sequences to penetrate the polycondensate and to interact strongly, thus giving rise to micrometer/submicrometer 3-D structures exhibiting high biological activity. The integration of such a biopatterning approach in the microfabrication process of silicon analytical devices has been demonstrated via the successful completion of immunoassays and nucleic acid assays.