A two-stage cascaded power amplifier (PA) employing a proposed Resistor-Capacitor (RC) interstage was provided and simulated. The current-reuse topology is employed at the first stage to lower the power consumption, while the RC interstage helps to enrich the gain flatness and the wideband matching. The shunt peaking topology in a common source configuration is adopted at the second stage to enhance the power gain. The postlayout simulation is performed using the TSMC 65 nm CMOS process operating in a frequency band of 3.1 GHz to 10.6 GHz. The postlayout simulation results indicate that a high flat gain of approximately 22.8 ± 1.2 dB, small group delay variation of ±50 ps, and good input and output matching of less than −10 dB are achieved over the desired working band. Moreover, a saturated output power of 10 dBm and maximum power-added efficiency (PAE) of 29.5% is achieved at 6 GHz. The proposed PA consumes the low power of 15.5 mW from 1.2 V supply voltage.
A memristor element has been highlighted in recent years and has been applied to several applications. In this work, a memristor-based digital to analog converter (DAC) was proposed due to the fact that a memristor has low area, low power, and a low threshold voltage. The proposed memristor DAC depends on the basic DAC cell, consisting of two memristors connected in opposite directions. This basic DAC cell was used to build and simulate both a 4 bit and an 8 bit DAC. Moreover, a sneak path issue was illustrated and its solution was provided. The proposed design reduced the area by 40%. The 8 bit memristor DAC has been designed and used in a successive approximation register analog to digital converter (SAR-ADC) instead of in a capacitor DAC (which would require a large area and consume more switching power). The SAR-ADC with a memristor-based DAC achieves a signal to noise and distortion ratio (SNDR) of 49.3 dB and a spurious free dynamic range (SFDR) of 61 dB with a power supply of 1.2 V and a consumption of 21 µW. The figure of merit (FoM) of the proposed SAR-ADC is 87.9 fj/Conv.-step. The proposed designs were simulated with optimized parameters using a voltage threshold adaptive memristor (VTEAM) model.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.