Morphologically driven dynamic wickability is essential for determining the hydrodynamic status of solid-liquid interface. We demonstrate that the dynamic wicking can play an integral role in supplying and propagating liquid through the interface, and govern the critical heat flux (CHF) against surface dry-out during boiling heat transfer. For the quantitative control of wicking, we manipulate the characteristic lengths of hexagonally arranged nanopillars within sub-micron range through nanosphere lithography combined with top-down metal-assisted chemical etching. Strong hemi-wicking over the manipulated interface (i.e., wicking coefficients) of 1.28 mm/s0.5 leads to 164% improvement of CHF compared to no wicking. As a theoretical guideline, our wickability-CHF model can make a perfect agreement with improved CHF, which cannot be predicted by the classic models pertaining to just wettability and roughness effects, independently.

Enhancing the critical heat flux (CHF), which is the capacity of heat dissipation, is important to secure high stability in two-phase cooling systems. Coolant supply to a dry hot spot is a major mechanism to prevent surface burn-out for enhancing the CHF. Here, we demonstrate a more ready supply of coolant using aligned silicon nanowires (A-SiNWs), with a high aspect ratio (>10) compared to that of conventional random silicon nanowires (R-SiNWs), which have a disordered arrangement, for additional CHF improvement. We propose the volumetric wicking rate, which represents the coolant supply properties by considering both the liquid supply velocity and the amount of coolant (i.e., wicking coefficient and wetted volume, respectively). Through experimental approaches, we confirm that the CHF is enhanced as the volumetric wicking rate is increased. In good agreement with the fabrication hypothesis, A-SiNWs demonstrate higher coolant supply abilities than those of R-SiNWs. The longest (7 μm) A-SiNWs have the highest volumetric wicking rate (25.11 × 10 mm/s) and increase the CHF to 245.6 W/cm, which is the highest value obtained using nanowires among reported data (178 and 26% enhanced vs unmodulated plain surface and R-SiNWs, respectively). These well-aligned SiNWs can increase the CHF significantly with efficient coolant supply, and it can ensure high stability in extremely high thermal load systems. Moreover, our study provides nanoscale interfacial design strategies for further improvement of heat dissipation.

No abstract

No abstract

No abstract

The objective of this study is to design a broadband and wide-angle emitter based on metamaterials with a cut-off wavelength of 2.1 µm to improve the spectral efficiency of thermophotovoltaic emitters. To obtain broadband emission, we conducted the geometric parameter optimization of the number of stacked layers, the inner and outer radii of the nano-rings, and the thickness of the nano-rings. The numerical simulation results showed that the proposed emitter had an average emissivity of 0.97 within the targeted wavelength, which ranged from 0.2 µm to 2.1 µm. In addition, the presented multilayer nano-ring emitter obtained 79.6% spectral efficiency with an InGaAs band gap of 0.6 eV at 1400 K.

We report combined electrochemical double-layer capacitance (EDLC) and pseudocapacitance in reduced graphene oxide (rGO) thick film like paper due to annealing temperature variations. The influence of annealing temperature (from room temperature (RT) to 1000 C) on the structural, morphological, electrical, and electrochemical properties of rGO paper was evaluated. Upon increasing the annealing temperature, shifting of the dominant (002) X-ray diffraction (XRD) peak to a higher degree, volume expansion, and red-shifting of the G band in Raman spectra were observed. High-resolution transmission electron microscopy (HRTEM) images showed a reduction in the interlayer distance in rGO sheets from 0.369 to 0.349 nm as the annealing temperature increased from RT to 1000 C; these results were congruent with the XRD results. According to X-ray photoelectron spectroscopy (XPS), the presence of hydroxyl, carboxyl, and other oxygen-containing groups decreased in samples annealed at higher temperatures. The attached functional groups, the electrical conductivity, and the supercapacitance of rGO papers were found to be mutually interrelated and could be tuned by varying the annealing temperature. The rGO paper annealed at 200 C in a 1 M H 2 SO 4 electrolyte at a scan rate of 50 mV s À1 exhibited a maximum specific capacitance of 198 F g À1 .

We present a new concept of a structured surface for enhanced boiling heat transfer that is capable of self-adapting to the local thermal conditions. An array of freestanding nanoscale bimorphs, a structure that consists of two adjoining materials with a large thermal expansion mismatch, is able to deform under local temperature change. Such a surface gradually deforms as the nucleate boiling progresses due to the increase in the wall superheat. The deformation caused by the heated surface is shown to be favorable for boiling heat transfer, leading to about 10% of increase in the critical heat flux compared to a regular nanowire surface. A recently developed theoretical model that accounts for the critical instability wavelength of the vapor film and the capillary wicking force successfully describes the critical heat flux enhancement for the nanobimorph surface with a good quantitative agreement.