The production of low cost sensors to monitor environment in some industrial sectors is a current need. In aviculture centers, for example, the concentration of ammonia gas is related to humidity, and it is necessary to control it to avoid contamination. With this need in mind, this paper presents the preparation and characterization of a low cost humidity sensor based on poly(3,4-ethylenedioxythiophene)-poly(styrene sulfonate) and polyaniline fully printed onto paper by a commercial HP printer. Using electrochemical impedance spectroscopy, an equivalent circuit containing resistive and capacitive parameters was proposed. The resistive parameter R1 is related to values of ambient humidity. The R1 values showed a sensitive response of 200% when relative humidity changes 80%, taking 10 min to reach saturation point. Moreover, the device showed good stability when humidity remained constant. These results indicate that the proposed device is suitable for applying as a humidity sensor that costs less than 1 Euro cent.

No abstract

No abstract

Poly(3-hexylthiophene):6,13-bis(triisopropylsilylethynyl)-pentacene (P3HT:TP) blends with a ratio of 1:1 (wt/wt) were deposited via spin coating on anodized oxide (Al 2 O 3). A phase separation of the compounds was observed, resulting in the formation of crystalline aggregates of TP molecules that segregate vertically on the surface. The form of segregation depends on the oxide surface treatment used. Spectroscopy analysis shows a higher molecular order of P3HT in the blend than for neat film and that TP molecules are also distributed in the polymeric matrix. Regarding the OFET characteristics, charge carrier mobilities of 1.2 × 10 −3 cm 2 V −1 s −1 and 2.0 × 10 −3 cm 2 V −1 s −1 were obtained from devices for untreated and (hexamethyldisilazane) HMDS-treated Al 2 O 3 gate dielectric, respectively. These results confirm that P3HT:TP blends have good potential as an active layer in organic field effect transistors (OFETs).

No abstract

No abstract

No abstract

No abstract