Carbon nanotubes have attracted great interest in multidisciplinary study since their discovery. Herein, radionuclide 243Am(III) sorption to uncapped multiwall carbon nanotubes (MWCNTs) was carried out at 20+/-2 degrees C in 0.01 and 0.1 M NaClO4 solutions. Effects of 243Am(III) solution concentration, ionic strength, and pH on 243Am(III) sorption to MWCNTs were also investigated. The sorption is strongly dependent on pH values and weakly dependent on the ionic strength in the experimental conditions. The results show that MWCNTs can adsorb 243Am(III) with extraordinarily high efficiency by forming very stable complexes. Chemisorption or chemicomplexation is the main mechanism of 243Am(III) sorption on the surface of MWCNTs. MWCNTs can be a promising candidate for the preconcentration and solidification of 243Am(III) or its analogue lanthanides and actinides from large volumes of aqueous solution, as required for remediation purposes, and perhaps also as a sorbent for the removal of heavy metal ions from the industry wastewater.

No abstract

No abstract

Measurement of dissolved reactive phosphorus (DRP) by the diffusive gradients in thin films (DGT) technique was investigated using a new binding phase. Half-dried amorphous zirconium oxide (with 50 ± 5% of water content) was mixed with acrylamide solution for the preparation of the new binding phase. The resulting binding gel had a high binding capacity (223 μg P cm(-2)) for phosphate. The solution of NaOH (1 M) was used for elution of phosphate from the gel, and an elution efficiency of 0.95 was obtained. A test of DGT uptake with this gel showed its dependence on temperature, and there was no influence of pH (3 to 10) and ionic strength (10 nM to 0.1 M). Its capacity for DGT response exceeded 100 μg P cm(-2), corresponding to a DRP concentration of more than 20 mg L(-1) for a 24 h deployment with a standard DGT device at 25 °C, which was at least 50 times of the Fe-oxide gel commonly used in the present DGT technique. Measurements with this high-capacity DGT technique in a laboratory microcosm of homogeneously mixed sediments gave smooth and reproducible mass-depth profiles. This technique was well demonstrated by in situ measurements in algal- and macrophyte-dominated regions of Lake Taihu. The DGT-measured concentrations of DRP were on average 20% and 40% of the DRP concentrations in pore waters, respectively, indicating a partial resupply of the sediments to the pore waters with DRP.

We improve the surface of graphene by atomic layer deposition (ALD) without the assistance of a transition layer or surface functionalization. By controlling gas-solid physical adsorption between water molecules and graphene through the optimization of pre-H2O treatment and two-step temperature growth, we directly grew uniform and compact Al2O3 films onto graphene by ALD. Al2O3 films, deposited with 4-cycle pre-H2O treatment and 100-200 °C two-step growing process, presented a relative permittivity of 7.2 and a breakdown critical electrical field of 9 MV/cm. Moreover, the deposition of Al2O3 did not introduce any detective defects or disorders in graphene.

Porous hollow MgO microspheres were synthesized and characterized by X-ray diffraction, field emission scanning electron microscopy, transmission electron microscopy, and nitrogen adsorptiondesorption isotherms. The removal properties of the MgO microspheres towards toxic fluoride were investigated, including adsorption kinetics, adsorption isotherms, and influences of pH and coexisting anions. The adsorption capacity was larger than 120 mg g À1 at a pH of 7.0. The effects of anions on fluoride removal were also investigated. The results indicated that phosphate was the greatest competitor of fluoride for adsorptive sites. In addition, the removal mechanism was revealed by Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy. The reaction of MgO and water molecules resulted in the formation of Mg(OH) 2 . The excellent adsorption properties towards fluoride resulted from the surface reaction between the generated Mg(OH) 2 and fluoride in solution.

No abstract

The reassessments of environmental processes in sediments rely upon capturing the heterogeneous features of elements at a small scale and at the same location. In this study, a diffusive gradients in thin films (DGT) technique was developed for the high-resolution simultaneous measurements of dissolved reactive phosphorus (DRP) and dissolved sulfide. A new binding gel was used in this DGT technique, which was prepared by incorporating AgI particles into the zirconium oxide binding gel previously used in the DGT measurement of DRP. The concentrations of the DRP and sulfide loaded into the binding gel were determined by a routine procedure and a computer-imaging densitometry (CID) technique, respectively. The performance of this DGT technique was tested under laboratory conditions and applied to in situ measurements in sediments of a shallow lake. Simultaneous release of DRP and dissolved sulfide was observed in a sulfide microniche with a diameter of ∼3 mm and in locally aggregated zones with a length over 1 cm, which was attributed to the simultaneous reductions of Fe(III) and sulfate and the associated release of Fe-bound P in the zones of the reactive organic matter in sediments. The good performance of this technique implies that there is a great potential for the development of new DGT techniques capable of simultaneous measurements of more analytes.