No abstract

No abstract

The adulteration of whiskey with analgesics and sedation drugs has been a common practice to prevent hangover the following day and promote loss of consciousness. In both situations, the portable and low cost detection platforms are of paramount importance for forensic investigations. This report describes the use of electrochemical paper‐based analytical devices (ePADs) fabricated by pencil drawing for detecting metamizole, paracetamol and midazolam maleate in whiskey. Different types of paper substrates and graphite pencils were initially characterized with ferrocyanide. The best results were achieved using vegetal paper and Aquarelle/6B pencils. ePADs revealed a decrease in current signal indicating a short lifetime, thus limiting their use to disposable sensors. Despite the short lifetime, the graphite pencil ePADs revealed good electrochemical reproducibility (RSD=3.3 %). The forensic feasibility of the proposed ePADs was demonstrated through the analysis of metamizole and paracetamol in whiskey. The limit of detection (LOD) achieved for paracetamol and metamizole were 45 and 20 mg L−1, respectively. ePADs were also tested to detect midazolam maleate in whiskey. The signal recorded exhibited linear correlation in a wide concentration range (25–1000 mg L−1) and a LOD of ca. 5 mg L−1. Considering the disposability and operational simplicity, ePADs offer a good strategy for detecting adulterations in alcoholic beverages at the point‐of‐need.

This paper describes for the first time the fabrication of pencil drawn electrodes (PDE) on paper platforms for capacitively coupled contactless conductivity detection (C(4) D) on electrophoresis microchips. PDE-C(4) D devices were attached on PMMA electrophoresis chips and used for detection of K(+) and Na(+) in human tear samples. PDE-C(4) D devices were produced on office paper and chromatographic paper platforms and their performance were thoroughly investigated using a model mixture containing K(+) , Na(+) , and Li(+) . In comparison with chromatographic paper, PDE-C(4) D fabricated on office paper has exhibited better performance due to its higher electrical conductivity. Furthermore, the detector response was similar to that recorded with electrodes prepared with copper adhesive tape. The fabrication of PDE-C(4) D on office paper has offered great advantages including extremely low cost (< $ 0.004 per unit), reduced fabrication time (< 5 min), and minimal instrumentation (pencil and paper). The proposed electrodes demonstrated excellent analytical performance with good reproducibility. For an inter-PDE comparison (n = 7), the RSD values for migration time, peak area, and separation efficiency were lower than 2.5, 10.5, and 14%, respectively. The LOD's achieved for K(+) , Na(+) , and Li(+) were 4.9, 6.8, and 9.0 μM, respectively. The clinical feasibility of the proposed approach was successfully demonstrated with the quantitative analysis of K(+) and Na(+) in tear samples. The concentration levels found for K(+) and Na(+) were, respectively, 20.8 ± 0.1 mM and 101.2 ± 0.1 mM for sample #1, and 20.4 ± 0.1 mM and 111.4 ± 0.1 mM for sample #2.

We describe the development of a paper electrophoresis chip integrated with pencil electrodes for contactless conductivity detection and its application in the separation of biomolecules associated with kidney dysfunctions.