Extracellular vesicles (EVs) are the substances that are released by most types of cells and have an important role in cell to cell communication. Among the most highly researched EVs are exosome. Recent studies show that exosomes derived from cells have different roles and targets. Many studies show that exosome can efficiently deliver many different kinds of cargo to the target cell. Therefore, they are often used to deliver therapeutic cargo for treatment. The exosomes that have been used include both natural ones and those that have been modified with other substances to increase the delivery ability. This article provides a review of both exosomes derived from various cells and modified exosome and their ability in delivering the many kinds of cargo to the target cell.

No abstract

Since its invention in 1981, scanning tunnelling microscopy (STM) is well-known for its supreme imaging resolution enabling one to observe atomic-scale structures, which has led to the flourishing of nanoscience. As successful as it is, there still remain phenomena which are observed using STM but are beyond our understanding. Graphite is one of the surfaces which have been most extensively studied using STM. However, there are a number of unusual properties of graphite surfaces. First reported in the 1980s, superlattices on graphite have since been observed many times and by many groups, but as yet our understanding of this phenomenon is quite limited. Most of the observed superlattice phenomena are widely believed to be the result of a Moiré rotation pattern, arising from the misorientation between two graphite layers, as verified experimentally. A Moiré pattern is a lattice with larger periodicity resulting from the overlap of two lattices with smaller periodicities. As graphite layers are composed of hexagonal lattices with a periodicity of 0.246 nm, as observed using STM, when there are misoriented graphite layers overlapping each other, a Moiré pattern with larger periodicity, depending on the misorientation angle, will be produced and appear as a superperiodic hexagonal structure on top of the graphite atomic lattice of the topmost surface layer. It is important to study graphite superlattices because, firstly, knowledge of this phenomenon will enable us to properly interpret STM images; secondly, it helps us to understand the correlation between electronic structures and atomic-structure rearrangement of graphite which is of tremendous aid for engineering material properties; thirdly, and perhaps most importantly, the observation of the phenomenon exhibits the capability of STM to produce images indicating the nature of internal defects which are below the surface. Over recent years, experimental and modelling techniques have been developed to study this anomalous regime of STM; however, there is a lack of a systematic classification of this scattered information. This review article thus serves the purpose of organizing all these results so as to enable a more comprehensive understanding of this phenomenon. We review the discovery of graphite superlattices, the observation of the associated properties, and the research efforts on this subject. An effort is made to envision the future experimental and theoretical research possibilities to unveil the mystery of this anomaly of STM. Applications of graphite superlattices are also proposed.

By combining the spatial resolution of a scanning-tunneling microscope (STM) with the electronic spin sensitivity of electron-spin resonance, we show that it is possible to detect the presence of localized spins on surfaces. The principle is that a STM is operated in a magnetic field, and the resulting component of the tunnel current at the Larmor (precession) frequency is measured. This component is nonzero whenever there is tunneling into or out of a paramagnetic entity. We have succeeded in obtaining spectra from free radical molecules from which the g factor of a spin entity may be inferred. For the molecules studied here, α,γ-bisdiphenylene-β-phenylallyl, g was found to be 2±0.1.

An analysis of polycrystalline Au thin film interconnects of widths ranging from 850 to 25 nm, and lengths ranging from 1.0 μm to 20 nm which have been electrically stressed to the point of failure is presented. For the longer wires (widths 60–850 nm), the failure current density is typically found to be 1012 A m−2, essentially independent of the wire width, and then rapidly approaching zero for thinner wires. For the wider wires, failure occurs at the end towards the negative electrode; for narrow wires, failure tends to occur towards the center of the wire, as observed using scanning electron microscopy and atomic force microscopy. The mean time to failure for fixed current density is seen to decrease with decreasing wire width. The failure current density for a given wire width increases as the length decreases. An analysis of the temperature profile based on calculations of a simple model is presented which shows that this width-dependent behavior of narrow lines is not anticipated from the assumption of a homogeneous line subject to thermally-assisted electromigration alone.

Nanotechnology-based antitumor drug delivery systems, known as nanocarriers, have demonstrated their efficacy in recent years. Typically, the size of the nanocarriers is around 100 nm. It is imperative to achieve an optimum size of these nanocarriers which must be designed uniquely for each type of delivery process. For pH-responsive nanocarriers with programmable size, changes in pH (~6.5 for tumor tissue, ~5.5 for endosomes, and ~5.0 for lysosomes) may serve as an endogenous stimulus improving the safety and therapeutic efficacy of antitumor drugs. This review focuses on current advanced pH-responsive nanocarriers with programmable size changes for anticancer drug delivery. In particular, pH-responsive mechanisms for nanocarrier retention at tumor sites, size reduction for penetrating into tumor parenchyma, escaping from endo/lysosomes, and swelling or disassembly for drug release will be highlighted. Additional trends and challenges of employing these nanocarriers in future clinical applications are also addressed.

Enhanced piezoresponse force microscopy was used to study flux closure vortexlike structures of 90° ferroelastic domains at the nanoscale in thin ferroelectric lead zirconium titanate (PZT) films. Using an external electric field, a vortexlike structure was induced far away from a grain boundary, indicating that physical edges are not necessary for nucleation contrary to previous suggestions. We demonstrate two different configurations of vortexlike structures, one of which has not been observed before. The stability of these structures is found to be size dependent, supporting previous predictions.

We report the self-assembly of single crystals of single-walled carbon nanotubes (SWCNTs) using thermolysis of nano-patterned precursors. The synthesis of these perfectly ordered, single crystals of SWCNTs results in extended structures with dimension on the micrometer scale. Each crystal is composed of an ordered array of tubes with identical diameters and chirality, although these properties vary between crystals. The results show that SWCNTs can be produced as a perfect bulk material on the micrometer scale and point toward the synthesis of bulk macroscopic crystalline material.