Result of the present study found that medical and dental residents are not sufficiently prepared to endure their role in protection of child from abuse. A significant gap existed between recognizing signs of physical child abuse and responding effectively. Improvements in child abuse education and continuing education courses are advised to provide adequate knowledge.
Introduction: Microleakage is an important property that has been used in assessing the success of any restorative material used in restoring a tooth. Immediate application of a surface coating agent is suggested to protect glass ionomer cement against moisture contamination and dehydration during early setting. Aim: To compare marginal microleakage of two different Glass Ionomer Cement (GIC)- Conventional GIC and Resin Modified GIC in primary anterior teeth using three surface coating materials. Materials and Methods: An in vitro study was conducted between January 2014 to October 2017 on freshly extracted 40 anterior primary teeth which were randomly assigned into two main groups (Fuji II GIC and Fuji II LC GIC) with four subgroups (control-no surface coating, A=GC Fují Varnish II, B=GC G-Coat Plus, C=Icon). A standardised Class V cavity preparation was prepared on the labial surface of each tooth. Specimens were coated with two layers of nail varnish, leaving a 1 mm window around the cavity margins and placed in a solution of Methylene blue Dye for 24 hour at 37°C. The teeth were sectioned longitudinally in a buccolingual direction of the restorations and evaluated under stereomicroscope to check extent of dye penetration. The results were analysed by ANOVA and Tukey’s post-hoc test (p≤0.05). Results: It was found that maximum microleakage was seen in group 1 (Fuji II GIC) as compared to group 2 (Fuji II LC GIC) and it was non-significant (p=0.53). Ascending order for mean microleakage for Group 1 was as follows: Control >GC Fuji Varnish >Icon DMG >GC G-Coat and for Group 2: Control >GC Fuji Varnish >Icon DMG >GC G-Coat. Icon when compared with Gc coat and Varnish also showed non-significant (p=0.137) difference in Group 2. Conclusion: All three different surface coatings can seal glass ionomer restorations. The GC G-Coat Plus has the least microleakage on Resin-Modified GIC (RMGIC) compared to the other surface coatings. This would aid the clinicians to make appropriate decision regarding the choice of material to be used for restoration and coating in anterior primary teeth.
A
bstract
Aim and objective
The aim and objective of this study was to do a comparative evaluation of microhardness and enamel solubility (ES) of the treated surface enamel with resin infiltrant, fluoride varnish, and casein phosphopeptide-amorphous calcium phosphate (CPP-ACP).
Materials and methods
An
in vitro
study was conducted on freshly extracted 85 sound permanent teeth of which 5 teeth were subjected to check for microhardness by the Vickers microhardness tester and the remaining teeth were exposed to demineralizing solution to create initial enamel lesions. These 80 teeth were assigned to four groups: group I—negative control (
n
= 20), group II—resin infiltrant (
n
= 20), group III—fluoride varnish (
n
= 20), and group IV—CPP-ACP (
n
= 20), and microhardness was checked after application. These teeth were exposed to caries attack three times a day for three consecutive days. The ES of these four groups was checked by calcium ion loss in the artificial cariogenic solution and whole saliva by an atomic absorption spectrophotometer.
Results
It was found that none of the experimental groups reached the microhardness values of sound intact teeth. At 3rd day, the values of microhardness were: group II = group III > group IV > group I. Maximum ES was found for group I (control) followed with group IV.
Conclusion
All agents used in study remineralized initial carious lesion. Fluoride varnish has the highest microhardness and showed least ES compared to other remineralizing agents.
Clinical significance
Fluoride varnish can be regarded as the choice of material to be used for the treatment of incipient carious lesions because of the low application frequency (once every 3–6 months), requires minimal patient compliance as it is a noninvasive procedure and less time consuming.
How to cite this article
Dhillon SN, Deshpande AN, Macwan C,
et al.
Comparative Evaluation of Microhardness and Enamel Solubility of Treated Surface Enamel with Resin Infiltrant, Fluoride Varnish, and Casein Phosphopeptide-amorphous Calcium Phosphate: An
In Vitro
Study. Int J Clin Pediatr Dent 2020;13(S-1):S14–S25.
It can be concluded that there is a need for provision of education and awareness to the primary health care providers which would help in improving pregnant women and infant's oral health status along with establishment of dental home.
The concept of presurgical nasoalveolar moulding (PNM) was developed to improve the aesthetic result of surgically corrected cleft lip. This paper presents the method of fabrication of PNM appliance and the case of a 30-day-old neonate with unilateral cleft lip in whom nasal moulding was performed. Treatment was initiated at 30 days and continued for 60 days after which the surgical correction of cleft lip was performed. Significant improvement in aesthetics and symmetry of the nose was achieved at the end of the treatment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.