In this paper, we demonstrated the feasibility of the Aerosol Deposition (AD) method which can be adapted as a future fabrication process for flexible electronic devices. On the basis of this method’s noticeable advantages such as room-temperature processing, suitability for mass production, wide material selectivity, and direct fabrication on a flexible substrate, we fabricated and evaluated a flexible conductive bridge random access memory (CBRAM) to confirm the feasibility of this method. The CBRAM was fabricated by the AD-method, and a novel film formation mechanism was observed and analyzed. Considering that the analyzed film formation mechanism is notably different with previously reported for film formation mechanisms of the AD method, these results of study will provide strong guidance for the fabrication of flexible electronic device on ductile substrate.
Magnetic stimulation using implantable devices may offer a promising alternative to other stimulation methods such as transcranial magnetic stimulation (TMS) or electric stimulation using implantable devices. This alternative may increase the selectivity of stimulation compared to TMS, and eliminate the need to expose tissue to metals in the body, as is required in electric stimulation using implantable devices. However, previous studies of magnetic stimulation of the sciatic nerve used large coils, with a diameter of several tens of mm, and a current intensity in the order of kA. Since such large coils and high current intensity are not suitable for implantable devices, we investigated the feasibility of using a smaller implantable coil and lower current to elicit neuronal responses. A coil with a diameter of 3 mm and an inductance of 1 mH was used as the implantable stimulator. Before in vivo experiments, we used 3D computational models to estimate the minimum stimulus intensity required to elicit neuronal responses, resulting in a threshold current above 3.5 A. In in vivo experiments, we observed successful nerve stimulation via compound muscle action potentials elicited in hind-limb muscles when the applied current was above 3.8 A, a significantly reduced current than that used in conventional magnetic stimulation.
To overcome the limitations of muscle-based prostheses, studies on nerve-based prostheses for sensory feedback have recently been reported. To develop such prostheses, intrafascicular electrodes, a type of peripheral nerve interface, are essentially used to connect the nervous system and external systems. Through these electrodes, sensory feedback to induce sensations in patients is possible. To evoke natural sensations, precise recordings of nerve signals should precede sensory feedback, in order to identify patterns of sensory signals in the nerve and to mimic these patterns in stimulating the nerve. For this purpose, we previously developed a PDMS-based flexible penetrating microelectrode array (FPMA). In the current study, we verified the ability of the FPMA to record sensory nerve signals. The FPMA implanted in the rabbit sciatic nerve was able to record spontaneous neural signals, and the recorded signals were separated into action potential units. In addition, sensory nerve signals synchronized with ankle movement were successfully recorded, demonstrating that the FPMA is a useful peripheral neural interface capable of recording high-resolution sensory signals.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.