This is an open-access article distributed under the terms of the Creative Commons Attribution License.

Oral rehabilitation with osseointegrated implants is a way to restore esthetics and masticatory function in edentulous patients, but bacterial colonization around the implants may lead to mucositis or peri-implantitis and consequent implant loss. Peri-implantitis is the main complication of oral rehabilitation with dental implants and, therefore, it is necessary to take into account the potential effects of antiseptics such as chlorhexidine (CHX), chloramine T (CHT), triclosan (TRI), and essential oils (EO) on bacterial adhesion and on biofilm formation. To assess the action of these substances, we used the microcosm technique, in which the oral environment and periodontal conditions are simulated in vitro on titanium discs with different surface treatments (smooth surface -SS, acid-etched smooth surface -AESS, sand-blasted surface -SBS, and sand-blasted and acid-etched surface -SBAES). Roughness measurements yielded the following results: SS: 0.47 µm, AESS: 0.43 µm, SB: 0.79 µm, and SBAES: 0.72 µm. There was statistical difference only between SBS and AESS. There was no statistical difference among antiseptic treatments. However, EO and CHT showed lower bacterial counts compared with the saline solution treatment (control group). Thus, the current gold standard (CHX) did not outperform CHT and EO, which were efficient in reducing the biofilm biomass compared with saline solution.

We evaluated the influence of temperature on the ability of Salmonella Enteritidis (SE) to form biofilms on stainless steel, polyethylene, and polyurethane surfaces under different hygiene procedures. These materials were placed on SE culture and incubated at 42±1 ºC, 36±1 ºC, 25±1 ºC, 9±1 ºC, and 3±1 ºC for 4, 8, 12, and 24 h. Hot water at 45 ºC and 85 ºC, 0.5% peracetic acid solution, and 1% quaternary ammonia were used for hygienization. Biofilm formation occurred at all temperatures evaluated, highlighting at 3 ºC which has not been reported as an ideal temperature for the adhesion of SE to these materials. The SE adhered more often to polyethylene surfaces than to polyurethane and stainless steel surfaces (P<0.05). Peracetic acid and water at 85 ºC had similar hygienization efficiency (P<0.05) followed by quaternary ammonia whereas water at 45 ºC was not effective. SE adhered to these materials under low temperatures which to date have been deemed safe for food preservation.

Background: Salmonella spp. are frequently isolated from fowls, and their detection in poultry products varies according to the breeding system and the slaughtering process, bringing risks to the consumer and compromising the marketability. The control of Salmonella in poultry slaughterhouses is based on the detection of bacteria, but the quantification of the agent would be important in assessing risk, as well as in obtaining data to determine the capacity of each step of the process to decrease or increase bacterial contamination. The aims of this study were to propose a method for the quantification of Salmonella in poultry slaughterhouses, frequency of isolation and serovars identified.Materials, Methods & Results: Twenty-one broiler flocks from seven federally inspected slaughterhouses in southern Brazil, totaling 1,071 samples, were assessed by miniaturized most probable number (mMPN) and conventional microbiology. The samples were collected in triplicate at 17 points, which included cloacae, transportation cages before and after sanitization, water (scald tank, supply, pre-chiller and chiller), and carcasses (before and after scalding, defeathering, rinsing, evisceration, final rinsing, chilling at 4ºC, and freezing at -12°C for 24 h, 30 and 60 days). Typical Salmonella colonies were submitted to TSI, LIA, SIM, urea, and polyvalent anti-O antiserum tests, and to final identification by Microarray by Check&Trace. Nine of the 1,071 (0.83%) samples analyzed by mMPN and by conventional microbiology were positive for Salmonella and the following serovars were identified: Anatum, Brandenburg, Agona, Tennessee, Bredeney, Schwarzengrund and Infantis.Discussion: This positive rate was lower than that described by other authors, whose rates ranged from 3% and 39% for the isolation of Salmonella spp. from different sources, such as slaughterhouses and retail sales in samples collected in Brazil. The low frequency of isolation of Salmonella in this study can be attributed to the efficiency of control systems used from the field to the slaughterhouse, such as Good Manufacturing Practices (GMP) and Sanitation Standard Operating Procedures (SSOP), which are HACCP requirements. Also, when slaughtering technology actions are properly managed, such as water replacement and temperatures lower than 4ºC in the chiller, the initial contamination by Salmonella spp. can be reduced, with a decline in contamination from 70% to 20%, and with a reduction in the contamination of broiler carcasses after chilling from 15.8% to 3.3%. On the other hand the contamination of carcasses by Salmonella before pre-chilling and in post-chilling might be due to the automated system, inadequate temperatures during chilling, and inappropriate water chlorination in the assessed meat-packing plant. Of the 17 points evaluated, seven were positive for Salmonella, especially the cages after sanitization and frozen carcasses. The contamination by Salmonella spp. in transportation cages after sanitization indicates inefficiency of the automated system as well as possible bacterial resistance to the sanitizers used in SSOP while the isolation in carcasses frozen for 24 h and 60 days demonstrates the thermal resistance of the bacterium to a conservation method widely used in the food industry. In this work, just one of the nine positive samples for Salmonella was identified by conventional methods (CM) and mMPN. The discrepancy between methods can be explained by the heterogeneous distribution of Salmonella and other bacteria in naturally contaminated samples. Samples that were positive in the qualitative test but negative in the mMPN protocol could have had a number of Salmonella below the detection amount.

Background: The hygiene procedures in poultry slaughterhouses consist in the use of hot water, detergent and sanitizing, configuring Sanitation Standard Operating Procedure (SSOP). These actions control contamination in food processing environments, especially by pathogenic microorganisms, which cause diseases with impact on public health and economic losses. The microbiological control of aerobic mesophiles, Staphylococcus aureus and Escherichia coli, are used as indicators of contamination. The hygienic-sanitary conditions on the surfaces of the poultry slaughterhouse cuttting room were evaluated, before and after cleaning and sanitizing procedures.Materials, Methods & Results: Conventional microbiology (Rodac plates and sponge for quantification of aerobic mesophiles, Staphylococcus aureus and Escherichia coli) and ATP-Bioluminescence were used to analyze the action of hot water and the active principles peracetic acid, quaternary ammonia and biguanide in the standard pre-operational hygiene procedure in the cutting room of the poultry slaughterhouse under Federal Inspection with slaughter capacity of more than 20.000 birds/h. The evaluations were performed on three lines of chicken thigh cuts at the same time and in a completely randomized manner on stainless steel surfaces, polyurethane belts and polyethylene boards. Samples were made in four replicates at the three surface totaling 108 assay for each microorganism. The samples were collected at the end of the cuttingprocess, before and after washing the surfaces with hot water (between 45 and 50ºC) and after sanitization with 0.5% peracetic acid, 2% quaternary ammonia and 1% biguanide. The ATP-Bioluminescence method detected organic matter at all collected points and Rodac plates allowed a better recovery of microorganisms than sponges for quantification of aerobic mesophiles, E. coli and S. aureus. There was a reduction of contamination after the action of hot water and, after using quaternary ammonia and peracetic acid, there was no isolation of E. coli and S. aureus on all evaluated surfaces.Discussion: The use of different methods of analysis for monitoring the hygiene and sanitary status of contact surfaces with chicken cuts allows greater flexibility in relation to hygiene control. The use of the bioluminescent ATP detection method allows detecting in seconds extremely low levels of contamination, allowing a quick determination of the cleaning efficiency on the surfaces and evaluation of the hygiene programs. Conventional microbiology methods, on the other hand, provideindicators of contamination by different microorganisms on food contact surfaces. Both are applicable in SSOP monitoring programs and sanitary conditions of the contact surfaces in food producing establishments. The significant reduction of microorganisms on surfaces after cleaning, found in this study, demonstrates the importance of operational hygiene inthe maintenance of microbial contamination below the recommended limits, and to reconcile the ATP-Bioluminescence methodologies and Rodac plates can bring benefits to the control of this contamination, and the use of ATP-bioluminescence makes possible taking immediate corrective measures after the evaluation of sanitation procedures.Keywords: ATP-Bioluminescence, Rodac plates, Escherichia coli, mesophiles, Staphylococcus aureus.

No abstract

No abstract

No abstract