No abstract

Hydrogen redistribution under stress-induced hydrogen diffusion and corresponding fracture behaviour of a 960 MPa grade martensitic steel were studied. Slow strain rate tensile (SSRT) tests after hydrogen pre-charging were performed and the fracture surface was observed and analysed. The strain rate ranged from 10−6 to 10−4 s−1. In the pre-charged sample with a certain hydrogen content of 0.62 ppm, hydrogen distribution was homogeneous before the SSRT test. After tensile testing, brittle fracture features appeared in the centre of the fracture surface, while ductile features appeared in the surrounding area. Brittle region size increased with the strain rate slowing down in the range from 10−4 to 5 × 10−6 s−1, while it stabilised at the strain rate slower than 5 × 10−6 s−1. Relationship between the strain rate and the brittle region size was established and discussed based on the present data of hydrogen content in the material. This paper is part of a thematic issue on Hydrogen in Metallic Alloys

No abstract

Inclusion-induced pitting initiation mechanisms in X70 steel were investigated by scanning electron microscopy, scanning Kelvin probe force microscopy (SKPFM), immersion and electrochemical polarization tests in chloride-containing ion solutions. There are three inclusion types in the X70 steel. Corrosion test results indicated that pitting corrosion resistance of type A inclusion < type C inclusion < type B inclusion, i.e., (Mn, Ca)S < matrix < (Al, Ca)O. SKPFM test results show that the type A inclusion exhibited both lower and higher potentials than the matrix, while the type B inclusion exhibited higher potential than the matrix. The corrosion test and the SKPFM potential test results are consistent. Potentiodynamic polarization results indicate that the type A and C are active inclusions, while the type B is an inactive inclusion. Three kinds of possible mechanisms of inclusion-induced pitting corrosion are established for the X70 steel.

No abstract

Hydrostatic pressure effects on pitting initiation and propagation in X70 steel are investigated by evaluating metastable pitting probability using electrochemical methods and immersion corrosion tests in containing chlorine ion solution. Potentiodynamic tests indicated that hydrostatic pressure can decrease the breakdown potential and lead to a reduced transpassivity region. Metastable test results revealed that hydrostatic pressure can increase metastable pitting formation frequency and promote stabilization of metastable pitting growth. Electrochemical impedance spectroscopy (EIS) results indicate that Hydrostatic pressure decreases the charge transfer resistance and increases the dissolution rate within the cavities. Corrosion test results also indicated that pitting initiation and propagation are accelerated by hydrostatic pressure. Result validity was verified by evaluating metastable pitting to predict pitting corrosion resistance.

No abstract

No abstract