Abstract:The current paper aims to review tooling life span, failure modes and models in cold microforming processes. As there is nearly no information available on tool-life for microforming the starting point was conventional cold forming. In cold forming common failures are (1) over stressing of the tool; (2) abrasive wear; (3) galling or adhesive wear, and (4) fatigue failure. The large variation in tool life observed in production and how to predict this was reviewed as this is important to the viability of microforming based on that the tooling cost takes a higher portion of the part cost. Anisotropic properties of the tool materials affect tool life span and depend on both the as-received and in-service conditions. It was concluded that preconditioning of the tool surface, and coating are important to control wear and fatigue. Properly managed, the detrimental effects from surface particles can be reduced. Under high stress low-cycle fatigue conditions, fatigue failure form internal microstructures and inclusions are common. To improve abrasive wear resistance larger carbides are commonly the solution which will have a negative impact on tooling life as these tend to be the root cause of fatigue failures. This has significant impact on cold microforming.
This research project investigated the process conditions of using squeeze casting process to produce aluminium alloy preforms or billets for subsequent cold forging process. The comparative effects of heat treatments, their microstructures and mechanical properties were evaluated. Through these studies and experiments, the main emphasis is on the study of commercial material Al 6061, Al 2014 and Al 356 alloys. The formability of the alloys was carried out using forward and backward extrusion test at 50% area reduction at room temperature (cold extrusion). It was found that when wrought aluminium 6061, 2014 and 356 alloys were squeeze cast to form the preforms, the preform microstructures revealed very fine microstructures that are feasible to be cold extruded. In addition, after thermal annealing treatment of 6061 squeeze cast preforms, the samples showed a similar value of work hardening exponent value of 0?20 as compared to the wrought aluminium alloy 6061, with a workhardening exponent value of 0?21 obtained from the static compression test. Wrought aluminium alloys generally cost twice the amount as compared with casting ingots. The microstructures of the squeeze cast 6061 alloy showed no visible cracks or inclusions after the deformation by extrusion. The results of the studies showed that Al 6061 preforms via squeeze cast technique may be cold extruded or formed, which provide an alternative means for the production of billets for the cold extrusion or forging process.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.