Theoretical efficiency potential of GaN/InGaN/cSi tandem solar cells is investigated using two-dimensional numerical computer simulation (i.e. technology-based computer aided design tool: TCAD). With double-junction GaN/InGaN/cSi tandem design, a conversion efficiency of 27% is achieved using a 1.0 μm In 0.5 Ga 0.5 N absorber of top cell over crystalline silicon (cSi) bottom cell. This efficiency is further improved to 29.0% with grading of the In x Ga 1−x N absorber layer close to the top heterointerface (p + -GaN/n − -In x Ga 1−x N) of the solar cell. A maximum conversion efficiency is obtained when the band discontinuity ratio (i.e. E C : E V ) is set to 0.65:0.35. While efficiency remains approximately constant with moderate n-doping (up to 5 × 10 16 cm −3 ) in the top InGaN absorber layer, sensitivity of the efficiency to the interface trap density and trap cross-section (when traps are located only at the heterointerfaces) shows degraded behavior with increasing trap density and trap cross-section. A temperature coefficient for open-circuit voltage (efficiency) of −0.15 (−1.72 × 10 −3 • C −1 ), −0.09 (−0.95 × 10 −3 • C −1 ) and −0.2 (−2.38 × 10 −3 • C −1 )%/ • C for single heterojunction (SHJ), double-heterojunction (DHJ) and tandem-graded design is predicted from the numerical simulations.
In this paper, ab initio calculations are used to determine polarization difference in zinc blende (ZB), hexagonal (H) and wurtzite (WZ) AlN-GaN and GaN-InN superlattices. It is shown that a polarization difference exists between WZ nitride compounds, while for H and ZB lattices the results are consistent with zero polarization difference. It is therefore proven that the difference in Berry phase spontaneous polarization for bulk nitrides (AlN, GaN and InN) obtained by Bernardini et al. and Dreyer et al. was not caused by the different reference phase. These models provided absolute values of the polarization that differed by more than one order of magnitude for the same material, but they provided similar polarization differences between binary compounds, which agree also with our ab initio calculations. In multi-quantum wells (MQWs), the electric fields are generated by the well-barrier polarization difference; hence, the calculated electric fields are similar for the three models, both for GaN/AlN and InN/GaN structures. Including piezoelectric effect, which can account for 50% of the total polarization difference, these theoretical data are in satisfactory agreement with photoluminescence measurements in GaN/AlN MQWs. Therefore, the three models considered above are equivalent in the treatment of III-nitride MQWs and can be equally used for the description of the electric properties of active layers in nitride-based optoelectronic devices.
In this work, we study the emergence of polarization doping in AlxGa1−xN layers with graded composition from a theoretical viewpoint. It is shown that bulk electric charge density emerges in the graded concentration region. The magnitude of the effect, i.e., the relation between the polarization bulk charge density and the concentration gradient is obtained. The appearance of mobile charge in the wurtzite structure grown along the polar direction was investigated using the combination of ab initio and drift-diffusion models. It was shown that the ab initio results can be recovered precisely by proper parameterization of drift-diffusion representation of the complex nitride system. It was shown that the mobile charge appears due to the increase of the distance between opposite polarization-induced charges. It was demonstrated that, for sufficiently large space distance between polarization charges, the opposite mobile charges are induced. We demonstrate that the charge conservation law applies for fixed and mobile charge separately, leading to nonlocal compensation phenomena involving (i) the bulk fixed and polarization sheet charge at the heterointerfaces and (ii) the mobile band and the defect charge. Therefore, two charge conservation laws are obeyed that induces nonlocality in the system. The magnitude of the effect allows obtaining technically viable mobile charge density for optoelectronic devices without impurity doping (donors or acceptors). Therefore, it provides an additional tool for the device designer, with the potential to attain high conductivities: high carrier concentrations can be obtained even in materials with high dopant ionization energies, and the mobility is not limited by scattering at ionized impurities.
Ab initio simulations were applied for nonpolar GaN/AlN superlattices of various widths for the first time giving band diagrams and optical transition oscillator strengths. The results confirmed the absence of electric fields in m-plane GaN/AlN multiquantum well (MQW) systems leading to drastically different properties of polar and nonpolar systems, narrow polar and nonpolar GaN/AlN well properties, such as bandgap or oscillator strength. Wider wells show drastic differences related to the presence of electric fields in polar systems. Wide nonpolar wells have bandgaps following parabolic dependence resulting from localization energy. Polar wide well gaps are determined by spontaneous and piezoelectric fields that reduce bandgap for wider wells and barriers. Oscillator strength shows a more dramatic difference between polar and nonpolar wells. Drastic reduction in the oscillator strength is observed for wide polar MQWs. The decrease in the oscillator strength by several orders of magnitude is observed for the increase in the width of wells and barriers. The wide polar wells should have extremely ineffective radiative emission from both direct and across the barrier overlap of electron–hole wavefunctions.
ZnSe thin films prepared on substrate by electrochemical method were deposited at and further irradiated with gamma irradiation of Co-60 source. The optical properties of the films are investigated using UV-VIS measurements. Absorbance of the films are observed to reduce after irradiation with γrays of different dose. The wavelength of the optical absorbance (A) decreases as the irradiation dose increases [A(400Gy) > A(300Gy) > A(250Gy) > A(200Gy) > A(0Gy)]. Other Optical properties like Transmittance, Optical band gap, reflectance, absorption coefficient, extinction coefficient and refractive index are determined from the absorbance result. The transmittance increases while the absorption coefficient decreases with increase in wavelength. The energy band gap of the sample decreases as the irradiation doses/fluence increases (0Gy = 3.02eV, 200Gy = 2.68eV, 250Gy = 2.49eV, 300Gy = 2.25eV and 400Gy = 2.0eV). This shows that the increase in gamma irradiation doses (Co-60 source) reduced the band gaps of ZnSe thin films and hence modifies the other physical properties.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.