No abstract

No abstract

No abstract

A rapid and sensitive method has been developed for the analysis of 48 human prescription active pharmaceutical ingredients (APIs) and 6 metabolites of interest, utilizing selective solid-phase extraction (SPE) and ultraperformance liquid chromatography in combination with triple quadrupole mass spectrometry (UPLC-MS/MS). The single-cartridge extraction step was developed using a mixed mode reversed-phase/cation-exchange cartridge (Oasis MCX) and validated in both wastewater effluent and surface water. Recoveries for the majority of compounds ranged from 80% to 125%, with relative standard deviations generally below 15%. Analytes were quantified using a multiple injection analysis with four chromatographic runs, with a combined run time of 48 min and SPE-UPLC-MS/MS method detection limits ranging from 1.0 to 51 ng/L. The analysis of seven wastewater effluents and one surface water sample revealed at least one detection for 38 of the 54 compounds, with effluent concentrations ranging from 7 to 2950 ng/L and surface water concentrations ranging from 10 to 140 ng/L. This initial data demonstrates that a significant number of the selected target analytes are present in wastewater treatment plant discharges.

No abstract

Iopromide (an X-ray contrast agent) and trimethoprim (an antibacterial drug) are frequently detected pharmaceuticals in effluents of wastewater treatment plants (WWTPs) and in surface waters due to their persistence and high usage. Laboratory-scale experiments showed that a significantly higher removal rate in nitrifying activated sludge as compared to conventional activated sludge was observed for both iopromide and trimethoprim. When the activity of the nitrifying bacteria was inhibited, the percent removal of iopromide decreased from 97 to 86% while trimethoprim removal decreased from 70 to 25%. The metabolite of iopromide identified when nitrification was not inhibited was a dehydroxylated iopromide at the two side chains. However, when the nitrifying bacteria were inhibited the metabolite identified was a carboxylate, formed during the oxidation of the primary alcohol on the side chain of iopromide. These results suggest that the nitrifying bacteria are important in the observed biodegradation of iopromide in the activated sludge with higher solid retention time (SRT). Results from the laboratory-scale study were corroborated by the observed removal efficiencies in a full-scale municipal WWTP, which showed that iopromide (ranging from 0.10 to 0.27 microg/L) and trimethoprim (ranging from 0.0.08 to 0.53 microg/L) were removed more effectively in the nitrifying activate sludge which has a higher SRT (49 days) than in the conventional activated sludge (SRT of 6 days). In nitrifying activated sludge, the percent removal of iopromide in the WWTP reached 61%, while in conventional activated sludge, average removal was negligible. For trimethoprim, removal was limited to about 1% in the conventional activated sludge, while in the nitrifying activated sludge, the removal was increased to 50%.

When chemical or microbial contaminants are assessed for potential effect or possible regulation in ambient and drinking waters, a critical first step is determining if the contaminants occur and if they are at concentrations that may cause human or ecological health concerns. To this end, source and treated drinking water samples from 29 drinking water treatment plants (DWTPs) were analyzed as part of a two-phase study to determine whether chemical and microbial constituents, many of which are considered contaminants of emerging concern, were detectable in the waters. Of the 84 chemicals monitored in the 9 Phase I DWTPs, 27 were detected at least once in the source water, and 21 were detected at least once in treated drinking water. In Phase II, which was a broader and more comprehensive assessment, 247 chemical and microbial analytes were measured in 25 DWTPs, with 148 detected at least once in the source water, and 121 detected at least once in the treated drinking water. The frequency of detection was often related to the analyte's contaminant class, as pharmaceuticals and anthropogenic waste indicators tended to be infrequently detected and more easily removed during treatment, while per and polyfluoroalkyl substances and inorganic constituents were both more frequently detected and, overall, more resistant to treatment. The data collected as part of this project will be used to help inform evaluation of unregulated contaminants in surface water, groundwater, and drinking water.

Solid-phase extraction (SPE) and liquid chromatography in combination with ion trap mass spectrometry (LC/MS/MS) conditions were optimized for the simultaneous analysis of 13 antibiotics belonging to multiple classes and caffeine in 3 different water matrixes. The single-cartridge extraction step was developed using a reversed-phase cartridge, resulting in recoveries for the 14 compounds ranging from 71 to 119% with relative standard deviations of 16% or lower. The analytes were separated in one chromatographic run, and the SPE-LC/MS/MS detection limits ranged from 0.03 to 0.19 microg/L. The SPE procedure was validated in groundwater, surface water, and wastewater. The analysis of samples from each of the three water matrixes revealed clindamycin (1.1 microg/L) in surface water and multiple antibiotics in wastewater (0.10-1.3 microg/L). The use of identification points to unambiguously assign the identity of antibiotics in various water matrixes was applied to an ion trap data-dependent scanning method, which simultaneously collects full scan and full scan MS/MS data for the unequivocal identification of target analytes.