No abstract

No abstract

No abstract

Volatile fatty acids (VFAs) have become promising candidates for replacing the conventional expensive carbon sources used to produce polyhydroxyalkanoates (PHAs). Considering the inhibitory effect of VFAs at high concentrations and the influence of VFA mixture composition on bacterial growth and PHA production, a thorough investigation of different cultivation parameters such as VFA concentrations and composition (synthetic and waste-derived VFAs) media, pH, aeration, C/N ratio, and type of nitrogen sources was conducted. Besides common VFAs of acetic, butyric and propionic acids, Cupriavidus necator showed good capability for assimilating longer-chained carboxylate compounds of valeric, isovaleric, isobutyric and caproic acids in feasible concentrations of 2.5–5 g/L. A combination of pH control at 7.0, C/N of 6, and aeration of 1 vvm was found to be the optimal condition for the bacterial growth, yielding a maximum PHA accumulation and PHA yield on biomass of 1.5 g/L and 56%, respectively, regardless of the nitrogen sources. The accumulated PHA was found to be poly(3-hydroxybutyrate-co-3-hydroxyvalerate) with the percentage of hydroxybutyrate in the range 91–96%. Any limitation in the cultivation factors was found to enhance the PHA yield, the promotion of which was a consequence of the reduction in biomass production.

Acidogenic fermentation of chicken manure (CM) for production and recovery of volatile fatty acids (VFA) is an interesting biological waste-to-value approach compared to benchmark organic waste management strategies. Considering the wide range of high value applications of VFA, a semi-continuous immersed anaerobic membrane bioreactor (AnMBR) was applied to boost VFA productivity and yield, while reducing downstream processing stages assisting the recovery of VFA. In this regard, the effect of parameters such as pH and organic loading rates (OLR) on the overall bioconversion and filtration performance was investigated. Thermal-shocked CM was applied both as inoculum and substrate. A very high VFA yield (0.90 g-VFA/g-VS) was obtained in the treatment with no pH control (~8.2) at an OLR of 2 g-VS/(L·d), presenting 24% higher yield compared to that of the controlled pH. Batch assays further demonstrated the enhanced hydrolysis and acidogenesis activities at weak alkaline conditions. A long-term (78 days) fermentation and filtration was successfully performed, where stable membrane filtration performance was experienced for about 50 days under high-solid (suspended solid of 37–45 g/L) and high flux (20 L/(m2·h)) conditions. Results suggest that AnMBR of CM is a feasible and promising process for VFA production and recovery.

No abstract

Fungal biomass (FB), a by-product of the fermentation processes produced in large volumes, is a promising biomaterial that can be incorporated into poly(lactic acid) (PLA) to develop enhanced biocomposites that fully comply with the biobased circular economy concept. The PLA/FB composites, with the addition of triethyl citrate (TEC) as a biobased plasticizer, were fabricated by a microcompounder at 150 °C followed by injection molding. The effects of FB (10 and 20 wt %) and TEC (5, 10, and 15 wt %) contents on the mechanical, thermal and surface properties of the biocomposites were analyzed by several techniques. The PLA/FB/TEC composites showed a rough surface in their fracture section. A progressive decrease in tensile strength and Young’s modulus was observed with increasing FB and TEC, while elongation at break and impact strength started to increase. The neat PLA and biocomposite containing 10% FB and 15% TEC exhibited the lowest (3.84%) and highest (224%) elongation at break, respectively. For all blends containing FB, the glass transition, crystallization and melting temperatures were shifted toward lower values compared to the neat PLA. The incorporation of FB to PLA thus offers the possibility to overcome one of the main drawbacks of PLA, which is brittleness.

No abstract