Thermo-mechanical fatigue behavior of Ti-6-22-22 alloy

Yu, Zhenxin; Li, S. X.; Liu, Y. Y.; Lei, Jiafeng

doi:10.1007/s10853-005-4554-3

Cited by 3 publications

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Ti-6Al-4V alloy is a moderate intensity (α+β) type titanium alloy and it has the excellent comprehensive performance [3][4]. The typical two-phase (α+β) titanium alloy is used most widely [5].…”

Section: Introductionmentioning

confidence: 99%

Low Cycle Fatigue Behaviors of TI-6AL-4V Alloy Controlled by Strain and Stress

Wang

2012

KEM

View full text Add to dashboard Cite

The low cycle fatigue behaviors of TI-6AL-4V alloy controlled by strain were investigated by experiment. The fatigue tests were performed at room temperature, and cyclic strain and stress ratio are 0.1 with triangle load wave. The results show that TI-6AL-4V alloy is soften rapidly under the cyclic tensile stresses and it is harden rapidly under the cyclic compressive stresses during the initial-stage of strain controlled fatigue, and the rates of cyclic soften and cyclic harden are decreased with the fatigue progress. The soften rate is related to the cyclic strain but little to the cyclic stress during the overall fatigue progress. The change of cyclic stress is related to the macro friction stresses. The results of experiment show that obvious cyclic creep occurs under the stress controlled low cycle fatigue conditions, and the magnitude of cyclic creep strain is related to the maximum cyclic stress. The softening of tensile friction stresses is the main factor of cyclic creep.

show abstract

Section: Introductionmentioning

confidence: 99%