Sol–gel derived composite from bioactive glass–polyvinyl alcohol

Costa, Hermes S.; Rocha, Magda Francisca Goncalves; Andrade, Gláucia Manzan Queiroz de; Barbosa-Stancioli, Edel Figueiredo; Pereira, Marivalda M.; Oréfice, Rodrigo Lambert; Vasconcelos, Wander L.; Mansur, Herman S.

doi:10.1007/s10853-007-1875-4

Cited by 57 publications

(29 citation statements)

References 23 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…XRD analyses were conducted in the 2θ range from 3.03 to 89.91 • with steps of 0.06 • . Narrow peaks identified within the scan range were confirmed using previously published literature [30,31,34,45,46]. …”

Section: Crystallinity and Phase Characterization By X-ray Diffractionsupporting

confidence: 68%

“…BET results were used as supporting technique for morphology analysis (SEM). In previous papers of our group [33,34] porosity has been addressed through other methods, based on high bioactive glass content in the hybrid structure formation.…”

Section: Characterization Of Structure and Morphology By Sem And Bet mentioning

confidence: 99%

“…3b the bands related to Si-O-Si asymmetric and symmetric stretching modes are observed at approximately 1080 and 450 cm −1 , respectively. A typical absorption band observed in silica gel is located at 1640 cm −1 and is attributed to the deformation mode of adsorbed molecular water in the pores [34][35][36][37]. The presence of PVA and other polymers in hybrids significantly reduces the possibility of drying and ageing the systems at temperature above 40 • C. Also, the vibrational band at 950 cm −1 has been credited to the presence of silanol groups (Si-OH) usually found in silica synthesized via sol-gel method.…”

Section: Chemical Characterization By Ftir Spectroscopymentioning

confidence: 99%

See 2 more Smart Citations

Nanostructured poly(vinyl alcohol)/bioactive glass and poly(vinyl alcohol)/chitosan/bioactive glass hybrid scaffolds for biomedical applications

Mansur

Costa

2008

Chemical Engineering Journal

Self Cite

174

View full text Add to dashboard Cite

Section: Crystallinity and Phase Characterization By X-ray Diffractionsupporting

confidence: 68%

Section: Characterization Of Structure and Morphology By Sem And Bet mentioning

confidence: 99%

Section: Chemical Characterization By Ftir Spectroscopymentioning

confidence: 99%

See 1 more Smart Citation

Nanostructured poly(vinyl alcohol)/bioactive glass and poly(vinyl alcohol)/chitosan/bioactive glass hybrid scaffolds for biomedical applications

Mansur

Costa

2008

Chemical Engineering Journal

Self Cite

174

View full text Add to dashboard Cite

“…• C [18][19][20]. The hygroscopic character of the phosphate glasses is confirmed by the absorptions bands due to O-H groups observed in the range 4000-1500 cm −1 .…”

Section: Resultsmentioning

confidence: 70%

Thermal Effect of Er³⁺Ions Embedded in Smart Nano-Composite Oxide Material Prepared by Sol-Gel Technique

Battisha

Ayoub²,

Hashem

et al. 2017

Acta Phys. Pol. A

View full text Add to dashboard Cite

The phosphosilicate for planar waveguides fabrication by using sol-gel, and particularly erbium-doped waveguide amplifiers, is reviewed. In particular, efforts to use sol-gel to improve molecular homogeneity in Er-doped phosphosilicate-based monolith and thin films will be discussed. A variety of material studies was carried out to investigate and optimize the sample preparation condition for such application. These include X-ray diffraction, the Fourier transform infrared and optical transmittance, absorption and refractive index calculation. The erbium nitrate precursors use is shown to alter the Er 3+ ions doping in the prepared samples thermally treated in the final monolith glass form, in comparison to the use of thin film phosphosilicate sol-gel sample. Excess heat treatment is used to force prepared samples crystallization, moreover resulting photoluminescence analysis is used to detect the co-operative-up-conversion sample properties before and after heating.

show abstract

“…Hong et al [34] used a similar technique to produce 50wt% HA in PCL scaffolds and showed similar cell viability for rat bone marrow stromal cells, but with increased cell differentiation for the HA-PCL scaffolds than the non-reinforced PCL scaffolds. Costa et al [35,36] foamed polyvinyl alcohol (PVA) reinforced with 20 to 40wt% of 58%SiO 2 -33%CaO-9%P 2 O 5 to produce porous scaffolds. After morphological, chemical and mechanicacharacterisation the scaffolds were cultured with cells from the VERO line.…”

Section: Porous Manufacturementioning

confidence: 99%

Bioactive composites for bone tissue engineering

Tanner

2010

Proc Inst Mech Eng H

View full text Add to dashboard Cite

One of the major challenges of bone tissue engineering is the production of a suitable scaffold material. In this review the current composite materials options available are considered covering both the methods of both production and assessing the scaffolds. A range of production routes have been investigated ranging from the use of porogens to produce the porosity through to controlled deposition methods. The testing regimes have included mechanical testing of the materials produced through to in vivo testing of the scaffolds. While the ideal scaffold material has not yet been produced, progress is being made.

show abstract

Sol–gel derived composite from bioactive glass–polyvinyl alcohol

Cited by 57 publications

References 23 publications

Nanostructured poly(vinyl alcohol)/bioactive glass and poly(vinyl alcohol)/chitosan/bioactive glass hybrid scaffolds for biomedical applications

Nanostructured poly(vinyl alcohol)/bioactive glass and poly(vinyl alcohol)/chitosan/bioactive glass hybrid scaffolds for biomedical applications

Thermal Effect of Er³⁺Ions Embedded in Smart Nano-Composite Oxide Material Prepared by Sol-Gel Technique

Bioactive composites for bone tissue engineering

Contact Info

Product

Resources

About

Sol–gel derived composite from bioactive glass–polyvinyl alcohol

Cited by 57 publications

References 23 publications

Nanostructured poly(vinyl alcohol)/bioactive glass and poly(vinyl alcohol)/chitosan/bioactive glass hybrid scaffolds for biomedical applications

Nanostructured poly(vinyl alcohol)/bioactive glass and poly(vinyl alcohol)/chitosan/bioactive glass hybrid scaffolds for biomedical applications

Thermal Effect of Er3+Ions Embedded in Smart Nano-Composite Oxide Material Prepared by Sol-Gel Technique

Bioactive composites for bone tissue engineering

Contact Info

Product

Resources

About

Thermal Effect of Er³⁺Ions Embedded in Smart Nano-Composite Oxide Material Prepared by Sol-Gel Technique