Punching test for estimating tensile strength and total elongation of steel sheets

Abstract

A punching test for simply estimating the tensile strength and total elongation of steel sheets and formed parts was proposed. The tensile strength and total elongation were estimated from the shear stress at the maximum punching load and percentage of the burnished depth at the sheared edge of the slug measured without cutting, respectively. For a variety of steel sheets with a range of the tensile strength from 360 to 1500 MPa, linear functions for the estimation were experimentally obtained. The correlation of the estimated tensile strength of the steel sheets with the measured one from the uniaxial tensile test was considerably high, and the correlation of the estimated total elongation was high. The distributions of tensile strength and total elongation for hot- and cold-stamped parts were estimated. The proposed punching test is available under not only a laboratory environment but also a factory environment.